Technical Service Bulletins (TSBs) for the 2008 ML320 are official communications between Mercedes-Benz & their dealerships that describe processes for troubleshooting or fixing certain common problems.
All vehicle manufacturers are required by U.S. law to make their TSBs available to the public.
XENTRY (MERCEDES): RATTLING NOISE COMING FROM THE AREA OF THE STEERING COLUMN TUBE SYSTEM, WHEN DRIVING OVER ROUGH ROAD AND WHEN ACCELERATING OR BRAKING, THERE WOULD BE CRACKING NOISES. MODELS 164, 251. NO MODEL YEARS LISTED. Read More »
XENTRY: RATTLING/THUMPING NOISES FROM THE AREA OF THE STEERING ON ROUGH ROADS OR WHEN DRIVING OVER ROAD UNDULATIONS. NO MODEL YEARS GIVEN. ALSO INCLUDED MODELS 168 AND 172. *JS Read More »
RATTLING/THUMPING NOISE ON ROUGH ROADS AND/OR KNOCKING NOISE WHEN MOVING STEERING IN BOTH DIRECTIONS ON ALL MODEL 164 AND 251 VEHICLES. MODEL YEARS UNKNOWN. *PE Read More »
MERCEDES: CHROME PLATING PEELING ON DECORATIVE CAPS ON THE STEERING WHEEL SPOKES, THIS IS DUE TO LESS THAN OPTIMAL ADHESION BETWEEN CHROME PLATING AND BASE MATERIAL. MODELS 164 AND 251. MODEL YEARS UNKNOWN. Read More »
XENTRY (MERCEDES): RATTLING NOISE COMING FROM THE AREA OF THE STEERING COLUMN TUBE SYSTEM, WHEN DRIVING OVER ROUGH ROAD AND WHEN ACCELERATING OR BRAKING, THERE WOULD BE CRACKING NOISES. MODELS 164, 251. NO MODEL YEARS LISTED. Read More »
XENTRY (MERCEDES): RATTLING NOISE COMING FROM THE AREA OF THE STEERING COLUMN TUBE SYSTEM, WHEN DRIVING OVER ROUGH ROAD AND WHEN ACCELERATING OR BRAKING, THERE WOULD BE CRACKING NOISES. MODELS 164, 251. NO MODEL YEARS LISTED. Read More »
MERCEDES: FOLLOWING FAULT CODES ARE ENTERED IN THE CONTROL UNIT AND DISPLAYED-FC5320 DRAIN VALVE:OPEN CIRCUIT OR INSUFFICIENT VALVE CURRENT IN MODELS SERIES 211, 219; FC5260 DRAIN VALVE OPEN CIRCUIT OR INSUFFICIENT VALVE CURRENT IN MODEL ... Read More »
MERCEDES: CHECK AIR SUSPENSION COMPRESSOR AND REPLACE IF NECESSARY. INSUFFICIENT AIR PRESSURE IN THE AIR SUSPENSION SYSTEM MAY RESULT FROM DAMAGE TO THE PRESSURE DISK IN THE AIR SUSPENSION COMPRESSOR. Read More »
SUSPENSION:FRONT:SPRINGS:AIR SUSPENSION:LINES AND FITTINGS
MERCEDES: FOLLOWING FAULT CODES ARE ENTERED IN THE CONTROL UNIT AND DISPLAYED-FC5320 DRAIN VALVE:OPEN CIRCUIT OR INSUFFICIENT VALVE CURRENT IN MODELS SERIES 211, 219; FC5260 DRAIN VALVE OPEN CIRCUIT OR INSUFFICIENT VALVE CURRENT IN MODEL ... Read More »
MERCEDES: CHECK AIR SUSPENSION COMPRESSOR AND REPLACE IF NECESSARY. INSUFFICIENT AIR PRESSURE IN THE AIR SUSPENSION SYSTEM MAY RESULT FROM DAMAGE TO THE PRESSURE DISK IN THE AIR SUSPENSION COMPRESSOR. Read More »
Engine diagnosis warning lamp lights up in instrument cluster, fault code U145400: "Implausible data were received from the ethanol sensor" Read More »
MERCEDES-BENZ: THE MALFUNCTION LIGHT IS ON WITH MULTIPLE POSSIBLE TROUBLE CODES STORED. THERE COULD BE A PROBLEM WITH THE CAMSHAFT AND/OR SCORING OF A PISTON. *RM Read More »
XENTRY (MERCEDES): ENGINE WARNING LAMP IS CURRENTLY ON OR WAS ON AND A DELAY FAULT OF THE CAMSHAFT ADJUST TO CURRENT OR STORED IN THE ENGINE CONTROL UNIT. MODELS 171, 203, 209, 211, 219, 221, 216, 230, 164, 251, AND 403. Read More »
MERCEDES BENZ: OIL LEAK AT THE ENGINE AIR INTAKE DUCT. OIL LEAKAGE AT THE AIR INTAKE DUCT DOWNSTREAM OF THE ENGINE AIR FILTER TO THE TURBOCHARGER, THE CAUSE MAY BE A DAMAGED OR INCORRECTLY INSTALLED SEAL. Read More »
CHECK ENGINE LIGHT ON / FAULT CODES FC1200 / FC1208 STORED IN ME-SFI CONTROL UNIT. MERCEDES-BENZ MODEL C230, C280, C350, SLK280, SLK350, CLK350, CLK550, E350, E550, CLS550, S600, AND SL550. EQUIPPED WITH M272 ENGINE OR M273 ENGINE. Read More »
ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:TURBO/SUPERCHARGER
MERCEDES BENZ: OIL LEAK AT THE ENGINE AIR INTAKE DUCT. OIL LEAKAGE AT THE AIR INTAKE DUCT DOWNSTREAM OF THE ENGINE AIR FILTER TO THE TURBOCHARGER, THE CAUSE MAY BE A DAMAGED OR INCORRECTLY INSTALLED SEAL. Read More »
ENGINE AND ENGINE COOLING:ENGINE:OTHER FUEL TYPES:TURBO/SUPERCHARGER
MERCEDES BENZ: OIL LEAK AT THE ENGINE AIR INTAKE DUCT. OIL LEAKAGE AT THE AIR INTAKE DUCT DOWNSTREAM OF THE ENGINE AIR FILTER TO THE TURBOCHARGER, THE CAUSE MAY BE A DAMAGED OR INCORRECTLY INSTALLED SEAL. Read More »
Combination message: "Clean fuel filter" is displayed. The fault code 162500 (water level message - Bosch) or P226997 (water level message - Delphi) or 171600 (filter load - Bosch) is stored in the engine control unit. Read More »
MERCEDES BENZ: WORK ON PRESSURE REGULATOR VALVE (AS OF CD13, 1600 BAR SYSTEM). FUEL LOSS AT THE PRESSURE REGULATOR VALVE AND/OR POOR ENGINE RUNNING CHARACTERISTICS (SHAKES, KNOCKS, SURGES, CHANGES TO LIMP HOME MODE, POOR OUTPUT, POOR ... Read More »
MERCEDES: ENSURING UNOBSTRUCTED MOVEMENT FOR THE FUEL LEVEL SENSOR. WHEN INSTALLING THE LEFT OR RIGHT FUEL LEVEL SENSOR, IT IS ESSENTIAL FOR IT TO HAVE UNRESTRICTED, UNOBSTRUCTED MOVEMENT. Read More »
Engine diagnosis warning lamp active. Fault code 20BE1B and/or 20BD1B (The heating element of the AdBlue tank has a malfunction) is logged in the Blue-Tec control unit. Read More »
Engine diagnosis warning lamp active. Fault code 20BE1B and/or 20BD1B (The heating element of the AdBlue tank has a malfunction) is logged in the Blue-Tec control unit. Read More »
This Service Campaign has been initiated because Daimler AG (DAG), the manufacturer of Mercedes-Benz vehicles, has determined that the mbrace software does not correspond to current production configuration. Read More »
The COMAND unit does not start or the COMAND display remains dark. The COMAND unit cannot be operated. Note: The problem disappears after a lengthy idle period (>6h) or after interrupting the power supply (circuit 30). Read More »
If it is necessary to replace an HV battery, the return will only be accepted with the filled-out ?Analysis Sheet for Transportability of High-Voltage Batteries Form? accompanied by: , the removed part, the quick test printout, the BMS ... Read More »
XENTRY (MERCEDES): ENGINE WARNING LAMP IS CURRENTLY ON OR WAS ON AND A DELAY FAULT OF THE CAMSHAFT ADJUST TO CURRENT OR STORED IN THE ENGINE CONTROL UNIT. MODELS 171, 203, 209, 211, 219, 221, 216, 230, 164, 251, AND 403. Read More »
MERCEDES: AIR MATIC VISIT WORKSHOP DISPLAYED WITHIN INSTRUMENT CLUSTER. MODELS 164, 211, 219, 221 AND 251. INCLUDED 4MATIC, AMG (COMPRESSOR) AMG, BLUETEC AND WAGON. MODEL YEARS UNKNOWN. *PE UPDATED 9/18/09. Read More »
MERCEDES: BATTERY SYMBOL AND SERVICE REQUIRED (IN WHITE). FAULT MESSAGE IS DISPLAYED IF THE CHARGE LEVEL IS TOO LOW OR THE PARK PAWL ADDITIONAL BATTERY IS DEFECTIVE. Read More »
MERCEDES: AIR MATIC VISIT WORKSHOP DISPLAYED WITHIN INSTRUMENT CLUSTER. MODELS 164, 211, 219, 221 AND 251. INCLUDED 4MATIC, AMG (COMPRESSOR) AMG, BLUETEC AND WAGON. MODEL YEARS UNKNOWN. *PE UPDATED 9/18/09. Read More »
MERCEDES: BATTERY SYMBOL AND SERVICE REQUIRED (IN WHITE). FAULT MESSAGE IS DISPLAYED IF THE CHARGE LEVEL IS TOO LOW OR THE PARK PAWL ADDITIONAL BATTERY IS DEFECTIVE. Read More »
MERCEDES: UPDATE REAR SAM SOFTWARE. THE OPENING AND CLOSING OF TAILGATE WITH KEY REMOTE, WHILE THE VEHICLE IS LOCKED, MAY CAUSE THE BATTERY TO DRAIN DUE TO INCORRECT REAR SAM REST CURRENT LOGIC. MODELS 164, 164.8, AND 251. Read More »
Lamp unit fogged or droplets forming. Due to the vent openings, the lamp unit is an "open system". This means that acidic gases, moisture, dirt and exhaust gases can penetrate it. This can result in deposits on the diffuser and lens. Read More »
Lamp unit fogged or droplets forming. Due to the vent openings, the lamp unit is an "open system". This means that acidic gases, moisture, dirt and exhaust gases can penetrate it. This can result in deposits on the diffuser and lens. Read More »
MERCEDES: STOP/TAIL LIGHT NOT ILLUMINATING WITH DTCS 9102, 9103, 9106, 9107, 9126, 9127 OR 9136. (VEHICLES WITHOUT LED TAIL LAMPS) *PE UPDATED 5/13/09. *PE UPDATED 4/20/11. REPAIR DOES NOT APPLY TO LED TAIL LAMPS. Read More »
Since 12/2012 (model 166) and since 06/2013 (model 242) the glass breakage loops are no longer in the side windows and rear window. Suitable interior protection ensures that the interior monitoring function continues to operate correctly. Read More »
MERCEDES: AIRBAG DURABILITY AND RELIABILITY. AIR BAG SRS CONTROL MODULE (N2/2) DOES NOT HAVE A SET SHELF LIFE AND WILL NORMALLY BE RELIABLE FOR THE LIFE OF A VEHICLE. Read More »
XENTRY: OUTSIDE DOOR HANDLE NO LONGER RETURNS TO END POSITION. DUE TO A BENT PIN IN THE DYNAMIC BALANCER, THE SUPPORT SPRING OF THE BEARING BRACKET CAN SLIDE OUT OF PLACE OR BECOME UNHOOKED. MODELS 164, 251, 166, 204, 212. Read More »
Crease formation on genuine leather seat covers in vehicles with low mileage ??A?A? Objects left on the seats for extended periods of time (pressure marks). ??A?A? Objects wedged between the seat backrest and seat cushion (e.g. Read More »
MERCEDES: THE ELECTRICALLY FOLDING 3RD SEAT ROW MAKES NOISES WHILE FOLDING UP AND DOWN, OR THE FOLDING FUNCTION DOES NOT WORK AT ALL. A WARNING MESSAGE ABOUT LOCKING THE 3RD SEAT ROW MAY ALSO APPEAR IN THE DISPLAY. Read More »
MERCEDES: ELECTRONIC STABILITY PROGRAM (ESP), STABILITY CONTROL (SR). REFERENCES REVISED AND REFERENCE TO AF DELETED/SUPERSEDES DTB TB 42.45/42. ESP LAMP ON. CONTACT FAULT AT CONNECTION FOR ESP CONTROL UNIT MK25 (N47). Read More »
Lamp unit fogged or droplets forming. Due to the vent openings, the lamp unit is an "open system". This means that acidic gases, moisture, dirt and exhaust gases can penetrate it. This can result in deposits on the diffuser and lens. Read More »
To enhance the satisfaction of our customers, avoid further costs of litigation and return focus to its core businesses, Mercedes-Benz USA, LLC (MBUSA) has entered into a settlement regarding claims relating to alleged mold and mildew ... Read More »
This Customer 1 Action has been initiated because certain mbrace subscribers were recently contacted by mbrace informing them that they need to have an i-button call performed to ensure their mbrace device has registered with the ... Read More »
MERCEDES: IT HAS BEEN DETERMINED THAT THE TELE AID MAY NOT FUNCTION PROPERLY AS A RESULT OF A HARDWARE FAULT IN THE TELE AID CONTROL MODULE. Read More »
MERCEDES: IT HAS BEEN DETERMINED THAT THE TELE AID MAY NOT FUNCTION PROPERLY AS A RESULT OF A HARDWARE FAULT IN THE TELE AID CONTROL MODULE. Read More »
