Technical Service Bulletins (TSBs) for the 2004 CLK320 are official communications between Mercedes-Benz & their dealerships that describe processes for troubleshooting or fixing certain common problems.
All vehicle manufacturers are required by U.S. law to make their TSBs available to the public.
XENTRY: RATTLING/THUMPING NOISES FROM THE AREA OF THE STEERING ON ROUGH ROADS OR WHEN DRIVING OVER ROAD UNDULATIONS. NO MODEL YEARS GIVEN. ALSO INCLUDED MODELS 168 AND 172. *JS Read More »
THE HIGH PRESSURE HYDRAULIC DISTRIBUTION HOSE OF THE ACTIVE BODY CONTROL (ABC) MAY DETERIORATE OVER TIME DUE TO EXCESSIVE EXPOSURE TO HUMIDITY AND HIGH TEMPERATURES. Read More »
BLEED BRAKE SYSTEM AND CHECK BRAKE SYSTEM FOR AIR ON THE SENSOTRONIC BRAKE CONTROL (SBC) SYSTEM USING STAR DIAGNOSIS. ALSO INCLUDES MERCEDES-BENZ 211 MODEL MY2004. *TT Read More »
PARKING BRAKE:CONVENTIONAL:MECHANICAL:LINKAGE AND CABLE
XENTRY (MERCEDES): ENGINE WARNING LAMP IS CURRENTLY ON OR WAS ON AND A DELAY FAULT OF THE CAMSHAFT ADJUST TO CURRENT OR STORED IN THE ENGINE CONTROL UNIT. MODELS 171, 203, 209, 211, 219, 221, 216, 230, 164, 251, AND 403. Read More »
COOLANT HOSE AT THE BOTTOM RIGHT OF THE RADIATOR MUST BE CHECKED TO DETERMINE WHETHER THE TWO CATCHES OF THE COOLANT HOSE ARE LATCHED CORRECTLY. INSPECT LATCHING OF LOWER RADIATOR HOSE, REPLACE RADIATOR IF NECESSARY. Read More »
Combination message: "Clean fuel filter" is displayed. The fault code 162500 (water level message - Bosch) or P226997 (water level message - Delphi) or 171600 (filter load - Bosch) is stored in the engine control unit. Read More »
MERCEDES: REPLACING THE LONGITUDINAL MEMBER (LEFT AND RIGHT) BELOW THE MAIN FLOOR PANEL ON ALL MY 204 UP TO 12/31/07. (C300, C350, C300 4-MATIC, C63 AME). *PE Read More »
MERCEDES: THE FUEL LEVEL INDICATED IN THE INSTRUMENT CLUSTER DOES NOT MATCH THE ACTUAL FILL LEVEL. THIS MAY BE CAUSED BY A FAULT IN THE FUEL LEVEL SENSOR FUNCTION CHAIN: HYDRAULIC AND ELECTRICAL LINES AND THEIR CONNECTIONS, REAR SAM OR ... Read More »
MERCEDES: REPLACING THE LONGITUDINAL MEMBER (LEFT AND RIGHT) BELOW THE MAIN FLOOR PANEL ON ALL MY 204 UP TO 12/31/07. (C300, C350, C300 4-MATIC, C63 AME). *PE Read More »
MERCEDES: THE FUEL LEVEL INDICATED IN THE INSTRUMENT CLUSTER DOES NOT MATCH THE ACTUAL FILL LEVEL. THIS MAY BE CAUSED BY A FAULT IN THE FUEL LEVEL SENSOR FUNCTION CHAIN: HYDRAULIC AND ELECTRICAL LINES AND THEIR CONNECTIONS, REAR SAM OR ... Read More »
Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end). Heard once when changing from forward to reverse (and vice versa) Read More »
INSPECT TRANSMISSION PILOT BUSHING AT ELECTROCHYDRAULIC UNIT AND REPLACE IF NECESSARY. THE TRANSMISSION PILOT BUSHING MAY HAVE BEEN INSTALLED ON THE CONTROL UNITS WITH NON-TEMPERED SEALING RINGS WHICH MAY CAUSE A SMALL LEAK TO OCCUR. Read More »
INSPECT TRANSMISSION PILOT BUSHING AT ELECTROCHYDRAULIC UNIT AND REPLACE IF NECESSARY. THE TRANSMISSION PILOT BUSHING MAY HAVE BEEN INSTALLED ON THE CONTROL UNITS WITH NON-TEMPERED SEALING RINGS WHICH MAY CAUSE A SMALL LEAK TO OCCUR. Read More »
INSPECT TRANSMISSION PILOT BUSHING AT ELECTROCHYDRAULIC UNIT AND REPLACE IF NECESSARY. THE TRANSMISSION PILOT BUSHING MAY HAVE BEEN INSTALLED ON THE CONTROL UNITS WITH NON-TEMPERED SEALING RINGS WHICH MAY CAUSE A SMALL LEAK TO OCCUR. Read More »
THE PVC SEAM SEAL ON THE TRANSMISSION SUPPORT BRACKET MAY NOT HAVE BEEN PROPERLY APPLIED. INSPECT TRANSMISSION SUPPORT SEAM SEAL, RESEAL IF NECESSARY. *TT Read More »
The presence of a quiescent current can have several causes. These are not always recognized and lead to an increased number of OK components being removed. Read More »
Malfunctions of various control units and/or on-board power supply problems caused by water in the control unit tray under the driver/front passenger seat (dislocated, pinched or leaking condensation ... Read More »
Malfunctions of various control units and/or on-board power supply problems caused by water in the control unit tray under the driver/front passenger seat (dislocated, pinched or leaking condensation ... Read More »
XENTRY (MERCEDES): ENGINE WARNING LAMP IS CURRENTLY ON OR WAS ON AND A DELAY FAULT OF THE CAMSHAFT ADJUST TO CURRENT OR STORED IN THE ENGINE CONTROL UNIT. MODELS 171, 203, 209, 211, 219, 221, 216, 230, 164, 251, AND 403. Read More »
MERCEDES VEHICLE: THE SRS INDICATOR LAMP IS ILLUMINATED AND CODE B1058 AND B2DBO ARE STORED, REPLACE THE SRS CONTROL UNIT. MODELS 203 AND MODEL 209. MODEL YEARS UNKNOWN. *PE Read More »
MERCEDES VEHICLES: THE XENON OR BI-XENON HEADLAMP NOT FUNCTIONING. A FUNCTION DESCRIPTION CAN BE FOUND IN WIS DOCUMENT GF8S.10-P-20010 (203), GF82.10-P-0003Q (209); GF82.10-P-3002R (230). MODEL YEARS UKNOWN. Read More »
MERCEDES VEHICLE: THE SRS INDICATOR LAMP IS ILLUMINATED AND CODE B1058 AND B2DBO ARE STORED, REPLACE THE SRS CONTROL UNIT. MODELS 203 AND MODEL 209. MODEL YEARS UNKNOWN. *PE Read More »
MERCEDES BENZ: FRONT OR REAR SEAT BELT DOES NOT ROLL UP CORRECTLY. DIRT DEPOSITS ON THE SEAT BELT GUIDE DUE TO SOILED SEAT BELT. ALSO INCLUDED MODELS 169, F CELL, 246, AND 231. NO MODEL YEARS GIVEN. Read More »
As previously reported, to enhance the satisfaction of our customers, avoid further costs of litigation and return focus to its core businesses, Mercedes-Benz USA, LLC (MBUSA) has entered into a Settlement regarding claims relating to ... Read More »
Noise complaints when load on backrest frame changes. Affects the driver and front passenger seats. Also perform the remedial action if you are performing work on: - backrest frame - backrest cover or - guide rail of head restraint. Read More »
As previously reported, to enhance the satisfaction of our customers, avoid further costs of litigation and return focus to its core businesses, Mercedes-Benz USA, LLC (MBUSA) has entered into a Settlement regarding claims relating to ... Read More »
INSPECT BOOT ON BOTH FRONT DOORS. THE BOOT AT THE DOOR CONNECTING TO THE A PILLAR MAY NOT HAVE BEEN CLIPPED CORRECTLY LEADING TO INSUFFICIENT SEALING. *NM Read More »
THE TRUNK LID SPRINGS COULD FAIL IN THE CLOSED TRUNK LID POSITION DUE TO EXTENSIVE EXPOSURE TO VERY HIGH TEMPERATURES. VOLUNTARY RECALL CAMPAIGN. COVER LETTER, RECALL CAMPAIGN BULLETIN AND LETTER TO OWNERS. Read More »
Crease formation on genuine leather seat covers in vehicles with low mileage ??A?A? Objects left on the seats for extended periods of time (pressure marks). ??A?A? Objects wedged between the seat backrest and seat cushion (e.g. Read More »
This Customer 1 Action has been initiated because certain mbrace subscribers were recently contacted by mbrace informing them that they need to have an i-button call performed to ensure their mbrace device has registered with the ... Read More »
