Official recalls have been issued for the 2020 Ford Explorer by the NHTSA. The complete details of all recalls are listed below, along with what they cover and the recommended solutions.
Recalls don't cost you anything to get fixed, but most are time-limited, so if your car is affected you should call your local Ford service department immediately!
If you have questions about a recall, write down your VIN & then call Ford customer service.
Without a label that shows the proper restraint usage guidelines, the occupants may have an increased risk of injury in the event of a crash. Read more »
A rearview camera that displays a blank or distorted image can reduce the drivers view of what is behind the vehicle, increasing the risk of a crash. Read more »
A disconnected driveshaft can result in a loss of drive power or a vehicle rollaway if the parking brake is not applied. Either of these scenarios can increase the risk of a ... Read more »
Without the electronic parking brake applied, the vehicle could rollaway if the driveshaft disconnects. A disconnected driveshaft can also result in a loss of drive power. Either of these scenarios can increase the risk of a ... Read more »
With a loose motor mount, motor vibration may cause the axle to disconnect from the engine and could result in loss of power, increasing the risk of a crash. Read more »
An incomplete weld securing the inlet check valve to the fuel tank shell could result in a substantial fuel leak during a crash, increasing the risk of fire. Read more »
Defective drive shafts may fail and cause a loss of connection between the transfer case and rear axle, possibly resulting in a vehicle rollaway when in Park or a loss of drive. Either condition can increase the risk of a crash. The drive shafts can also deform and separate from the driveline and potentially contact ... Read more »
Vehicles with seat belt buckles that are not properly secured may fail to restrain an occupant during a crash, increasing the risk of injury. Read more »
If the side air bag or seat back fasteners were not properly tightened, the side air bag deployment could be affected, increasing the risk of injury during a ... Read more »
The A/C pulley may rub through the wiring harness insulation and contact the unfused battery positive wire, resulting in a short circuit, increasing the risk of a ... Read more »
A seat back with an improperly assembled recliner mechanism may have reduced strength and may not adequately restrain an occupant in a crash, increasing the risk of ... Read more »
Without the cover, the MPR lever may be unintentionally moved, allowing the vehicle to roll away. Being in Factory Mode, the vehicle will not display warnings and/or gear selection on the instrument cluster. Both conditions increase the risk of a ... Read more »
