We purchased our vehicle new September 2023 from a Toyota dealership. Engine oil dipstick Toyota part 15301-50140 was installed in vehicle and was verified by 50140 stamped on dipstick. I wanted an extra oil dipstick so ordered a replacement through Toyota. The original dipstick part 15301-50140 is no longer available and has been superseded by Toyota part 15301-0P060. I ordered the new dipstick part number and received it from Toyota. It is verified by 0P060 stamped on the dipstick. The safety concern is the two dipsticks are not the same length and each one requires a different quantity of engine oil to reach the Full mark. The new dipstick -0P060 is 1/2 inch shorter than the old, no longer available dipstick -50140. Most importantly the Low and Full marks are also both 1/2 inch higher up or closer to dipstick handle on the new dipstick than the old one. It takes approximately 0.9 quart more of engine oil to reach Full on the new dipstick than on the old one. One of these dipsticks is correct for my vehicle and one is not. The original dipstick is no longer available and the new dipstick is not the same as the original. The difference of 0.9 quart more or less of oil in the engine is significant and important. Too much or too little oil can damage an engine or contribute to a shorter engine life. Both of these dipsticks cannot be correct for our vehicle. I have talked to the Service Managers at two Toyota Dealerships and they do not have an answer for why these dipsticks are different. I have spoken to Parts Department people at two additional Toyota Dealerships, called Toyota Motor North America and no one has any idea why these dipsticks are different or which one I should be using. I also wrote a letter to Toyota Motor NA Headquarters over two months ago and have received no response to date. I have both dipsticks available for inspection. Toyota needs to let owners know if they should replace their old dipsticks or not on these vehicles.

- Clovis, CA, USA