Flash: Powertrain Control Module (PCM) Updates
This bulletin involves reprogramming the Engine Control Module (ECM) / Powertrain Control Module (PCM) with the latest available software.
Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set:P20E8-00 - Reductant Pressure Too Low. P0301-00 - Cylinder 1 Misfire(Sym Cam Pump Only). P0302-00 - Cylinder 2 Misfire(Sym Cam Pump Only). P0303-00 - Cylinder 3 Misfire(Sym Cam Pump Only). P0304-00 - Cylinder 4 Misfire(Sym Cam Pump Only). P0305-00 - Cylinder 5 Misfire(Sym Cam Pump Only). P0306-00 - Cylinder 6 Misfire(Sym Cam Pump Only). P1C54-00 - SCR NOx Catalyst Missing. P242F-00 - Diesel Particulate Filter Restriction - Ash Accumulation(68RFE Only). P2463-00 - Diesel Particulate Filter Restriction - Soot Accumulation Bank 1(68RFE Only). P1451-00 - Diesel Particulate Filter System Performance(68RFE Only). P0299-00 - Turbocharger Underboost. P2706-00 - MS Solenoid Circuit (68RFE Only). P1D73-00 - AGS Performance. P061B - Internal Control Module Torque Calculation Performance. P064B-00 - PTO Control Module.
The customer may also notice the following:Harsh downshift clunk during exhaust brake deceleration. DEF gauge erratic when DEF level is low. Stall when putting in reverse in cold ambient temps. Engine stumble during engine warm up. Unstable idle when AC compressor cycles. Power Take Off (PTO) intermittently turns off with no DTCs. In addition the following software enhancements are included:Oil Change Monitor Improvements For Severe Duty Operation. System Improvement for PTO operation. wiTECH Mass Air Flow (MAF) data parameter improvement. Enabling wiTECH Particulate Matter (PM) Sensor Regeneration Test in PCM ?Misc Functions?. Active Grille Shutter (AGS) quality enhancements.
