The Tire Pressure Monitoring System (as mandated by NHTSA) fails to function properly. The system can be inspected upon request by the NHTSA because the local dealerships cannot determine the problem and refuse to contact the manufacture. Operating vehicles with over/under inflated ties causes numerous driving difficulties as well as premature and unnecessary wear on the tires. If it wasn't a concern the NHTSA wouldn't have mandated TPMS. Dealership refuses to acknowledge there is a problem. They just inflate the tires to the manufacturer recommendation and say its fixed. 2-3 days later the system tells me I have low tires. When I Check my tires with a Digital Gauge the tire pressure is correct. Problem started 10 months after purchasing this vehicle new in Jan 2022. After confirming with the dealership the installation of aftermarket Tires/Wheels would NOT void my warranty, I had the Dealer installed a set of aftermarket tires/wheels. They were supposed to remove the TP Sensors from each tire/wheel and installed in the new aftermarket tires/wheels. At this point I don't know if its a Tire Sensor problem, a problem with the system ( I believe behind the rear seat) that relays the information to the Dash Cluster or the Uconnect5 System where the Tire Pressures can be set. Dealer states I MUST inflate ties to the Tire Pressure Label installed by the manufacture on the Door Jam. I know from 23 year military transportation experience and having a friend loose his life because of over inflating a tire in the Vehicle Maintenance Shop as well as a Commercial Driver License Instructor You always use the information on the side of the tire provided by the Tire Manufacture. The Tire Pressure Monitoring System is accessed through the UConnect5 Computer System where the owner can program features associated with the vehicle such as Temperature, Lighting, Radio Stations, Tire Pressures and a host of other features.

- Gallipolis, OH, USA

the vehicle has been inspected by an independent engineer from Bosch, supplied by FCA (Fiat Chrysler Automobiles), it indicates that an expert assessment has been conducted. In this case, the following answers can be provided based on that information: 1. Components or systems that failed or malfunctioned: - Half shaft axle front left - Wheel assembly - Brake rotor disc - Suspension - Drive shaft - Transfer case - Right front axle shaft - Right front caliper - Right front caliper bolts 2. Availability for inspection upon request: The availability of the failed components for inspection may depend on the specific arrangements made between the vehicle owner and the independent engineer from Bosch. It is recommended to contact the engineer or FCA for further information regarding inspection availability. 3. Safety risks: Considering the multiple component failures mentioned, there is a significant safety risk not only to yourself but also to others. These failures can lead to loss of vehicle control, compromised braking, and potential accidents or collisions. 4. Confirmation by the independent engineer: Since the vehicle has been inspected by an independent engineer from Bosch, it suggests that the problems have been reproduced and confirmed. The engineer's evaluation should provide valuable insights into the nature and causes of the failures. 5. Inspection by manufacturer, police, insurance representative, or others: The information provided indicates that an independent engineer from Bosch, supplied by FCA, has inspected the vehicle. However, it is not specified whether the vehicle or its components have been inspected by other parties such as the manufacturer, police, or insurance representative. 6. Warning lamps, messages, or symptoms: Over the past months and throughout the last year, you have experienced multiple issues with the four-wheel drive system and e

- Durango, CO, USA

vehicle is less the 8 months old. Upon tire rotation, two front passanger wheel studs broke and one front drivers side wheel stud broke.

- Parkersburg, WV, USA