- November 3: Ram 1500 Recalled For Stability Control Problems recalls | 0 days ago
- October 31: Ram 1500 Classic Heated Trailer Tow Mirror Glass May Detach recalls | 3 days ago
- October 5: Recall: Ram 1500 Turn Signals May Not Self-Cancel recalls | 29 days ago
- September 30: ZF-TRW Airbag Failure Investigation Closed investigations | 34 days ago
- September 21: Toyota Corolla Cross Hybrid SUVs Recalled For Hard Brake Pedals recalls | 43 days ago
Ram TSB #18-057-15 REV A
2013 Ram 2500
TSB Document:
Affected Component: EQUIPMENT
- Summary
- Flash: 6.7L Diagnostic and System Improvements This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. Several software improvements are available for the following conditions. The Following DTC Has Been Changed From A Two Trip Fault To One Trip Fault: ? U1A24 - Lost Communication With Ammonia Sensor. Prevent Or Reduce Malfunction Indicator Lamp (MIL) Illumination When No Defect is Present For The Following Diagnostic Trouble Codes (DTCs). These Faults Have Been Changed From A One Trip Fault To A Two Trip Fault: ? P0201 - P0206 - Fuel Injector X Circuit/Open. ? P049D - EGR Control Position Exceeding Learning Limit. ? P0711 - Transmission Temperature Sensor Performance. ? P0712 - Transmission Temperature Sensor Low. ? P0713 - Transmission Temperature Sensor High. ? P0714 - Transmission Temperature Sensor Intermittent. ? P0740 - TCC Out Of Range. ? P0869 - Line Pressure High. ? P0933 - Hydraulic Pressure Sensor Range/Performance. ? P0934 - Line Pressure Sensor Circuit Low. ? P0935 - Line Pressure Sensor Circuit High. ? P1775 - Solenoid Switch Valve Latched In TCC Position. ? P1776 - Solenoid Switch Valve Latched In LR Position. ? U0100 - Lost Communication With ECM/PCM. ? U0002 - CAN C Bus Off performance - Bus Off. Improvements To Prevent Or Reduce Malfunction Indicator Lamp (MIL) Illumination When No Defect Is Present For: ? P205E - (Diesel Exhaust Fluid) Reductant Tank Temperature Sensor Circuit Intermittent (setting when the block heater is plugged in). ? U110E - Lost Ambient Temperature Message. ? P20E8 - (Diesel Exhaust Fluid) Reductant Pressure Too Low. ? P2281 Air Leak Between MAF And Throttle Body. ? U3017 - Control Module Timer/Clock Performance. ? P1477 - Dual Snorkle Calibration Change to Voltage Limit. ? P20EE - SCR NOX Catalyst Efficiency Below Threshold - Bank 1. ? P20E8 - (Diesel Exhaust Fluid) Reductant Pressure Too Low. ? U3017 - Control Modu
Click a tab for more information.