There is an armrest in the middle of the front seat of our car. It is intended to be the back support of the front center passenger seat. In conjunction with the seat belt, are to provide a safe ride for the middle passenger in the front seat of our car. A passenger in our car sitting in this position had the armrest break. This was under normal use. The car was not involved in an accident. The passenger was not very big. We hardly ever use this position as a seat. The armrest broke and projected into the rear seat compartment. The passenger in the middle of the front seat was thrust backward. In the event of an automobile accident / collision, both passengers in the middle of the front and back seats would be severely injured. The person in the back seat would be injured by hitting the head of the person in the front seat thrust back in the rear seating area or by hitting the arm rest that protrudes into the rear seating area. The person in the front seat would be thrust back toward the rear seating compartment with no back support. I spoke to my local dealer and was told this was not their problem to fix or rectify. I spoke to GMC and received a similar response GMC case no. 1-383907053, 12/28 (29)/2005 telephone number 866-932-4368 ext 35624, jessica paget the support materials for the armrest are obviously inadequate. This is a defect and a safety issue. This needs to be addressed, if not for this series of automobile, then for future automobiles using this method of construction. This armrest, when raised, should be a structure as strong as the adjoining seats. Or, the armrest should be eliminated and the seats extended to fill the space. If not, the armrest should be eliminated as a passenger seating position. This would include removing the seat belt which promotes it's use as a passenger seat. The vehicle should then not be promoted as having seating for six passengers.

- Allison Park, PA, USA

The head gasket sprung a leak of antifreeze that broke a rod inside the block and the engine has to be replaced. We also had a the upper pelenium break on it as well. It is a 1998 Pontiac Bonneville SE 3800 V6. We have to get a ride back to Minnesota and my car is in nd.

- Glencoe, MN, USA

Paint is peeling around key hole on trunk - at this time approximately a 5 inch diameter circle spot. The hood is turning milky looking. We took it to a local dealership where we were told that our car was in very good condition and had been taken very good care of. We were turned down due to being out of warranty and there are no recalls on your 1998 Bonneville regarding any paint concerns.

- Wilmington, NC, USA

Email fm donald mark (NY). A defective part called plenum caused problems in the consumer's vehicle, the consumer requested a recall to be issued. Scc

- New York, NY, USA

After refueling engine light illuminated. Took vehicle to dealer, dealer stated radiator needed water. Water was coming through radiator, and exiting through exhaust system. Please provide any further infomation.

- Pontotoc, MS, USA

This vehicle was in rearend collision and was totaled

- Columbia, MD, USA

Consumer complained of engine check light coming on at will. Engine check light had turned off at one occasion. On other occasion engine check light would come on for unknown reason. Vehicle has been in dealer shop, condition keeps reoccurring, and dealer informed cosumer nothing could be founed.

- Alma, MI, USA

While driving vehicle about 10 mph and sometimes higher speeds, according to consumer, the vehicle just shuts off, losing power and steering power. The engine check light comes on when engine stops. Consumer had taken vehicle to dealer twice they said: The problem is with the fuel pump that's why the engine was not working. Consumer states that the fuel pump was not the cause of the problem, possible engine problem.

- Gilbertsville, PA, USA