DTC C1116 AND/OR C1142 STORED IN THE
ABS CONTROL MODULE
IF YOU CONFIRM
Customer states the ABS warning light is ON and â??System fault See Ownerâ??s Manualâ??
appears in the message center (Figure 1),
AND
DTCs C1116 (Stop Lamp Switch) and/or C1142 (Press Sen Circuit) are stored in the ABS
Control Module.
ACTION
Follow the SERVICE PROCEDURE in this bulletin to:
1. Install the Center High Mount Stop Lamp (CHMSL) Relay and Jumper Harness.
2. Install a new Stop Lamp Switch.
3. Reprogram the ABS Control Module.
IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you
will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it
contains information that is essential to successfully completing this repair.
