- June 30: Nissan Frontier Ball Joint Problems Cause Recall recalls | 5 days ago
- June 15: Nissan ARIYA SUVs Recalled Over O-Ring and Oil Leak Problems recalls | 20 days ago
- June 4: Nissan Rogue Select Side Airbags Suddenly Deploy investigations | 31 days ago
- May 29: Urgent Exploding Airbag Warning For Older Nissan Models recalls | 37 days ago
- May 28: Automatic Emergency Braking Standard by September 2029 news | 38 days ago
Nissan TSB #NTB20-026
2010 Nissan Frontier
TSB Document:
Affected Component: EXTERIOR LIGHTING
- Summary
- 2005-2019 FRONTIER; HIGH-MOUNTED STOP LAMP SERVICE PART SERVICE INFORMATION The mounting stud diameter for the high-mounted stop lamp service part has changed from 5 mm to a 6 mm. If for any reason the high-mounted stop lamp needs to be replaced, the mounting hole will need to be enlarged to 6.5 mm (¼ inch) as follows: 1. Remove the high-mounted stop lamp.  - For high-mounted stop lamp removal, refer to the Electronic Service Manual: Section DRIVER CONTROLS > EXTERIOR LIGHTING SYSTEM > REMOVAL AND INSTALLATION > STOP LAMP. 2. Enlarge the high-mounted stop lamp’s mounting holes (see Figure 1 on page 2) using a 6.5 mm (¼ inch) drill bit. NOTICE: To avoid damage to the vehicle, apply light pressure to the drill while drilling. Excessive force may cause the drill bit to penetrate too far and damage the headliner. 3. Apply touch-up paint to the mounting holes to protect the bare metal. 4. Install the new high-mounted stop lamp using M6 mounting nuts. Refer to the PARTS INFORMATION on page 2.
Click a tab for more information.