Fuel Feeder Tube Clip
Dealer Inventory
*****Dealer Announcement*****
Nissan is issuing a quality hold to require dealers to inspect the Fuel Feeder Tube Clip position and confirm it is in the lock position on ~15,800 specific 2019 Altima vehicles identified in Service Comm. The clips may not be fully locked into place.
Affected vehicles are subject to stop sale and are either currently in dealer inventory or assigned and in transit to the dealer. Dealers must complete this inspection and if necessary, repair, prior to sale. The inspection and if necessary, repair; will take less than 15 minutes per vehicle to complete and no parts are required.
*****What Dealers Should Do*****
PLEASE FOLLOW THE ATTACHED REPAIR INSTRUCTIONS:
1. Verify if vehicles are affected by this quality action using Service Comm or DBS National Service History ? Open Campaigns I.D. PC669
- New vehicles in dealer inventory can also be identified using DBS (Sales-> Vehicle Inventory, and filter by Open Campaign).
- Refer to NPSB 15-460 for additional information
- Please continue to check newly arriving inventory for campaign applicability.
2. Dealers should inspect the Fuel Feeder Tube Clip position to confirm it is in the locked position.
3. Use the attached procedure to inspect any vehicles affected by this quality action:
- If inspection result is ?OK?, dealers may submit a warranty claim using Op Code PC6690 and release the vehicle.
- If the inspection result is ?NG? (clip is not fully locked into place)
- Take a photograph of the clip position and email it to: nnafqasupport@nissan-usa.com along with the following:
- E-mail subject line: PC669 (Altima Fuel Feeder Tube Clip)
- Attach Clear Pictures of the clip that is not locked into place.
- Dealer Name:
- Dealer Code:
- Dealer Address:
