Electrical corrosion of the harness could cause the seat belt pre-tensioner to malfunction, the side air bag not to deploy and/or the brake lamps not to illuminate or to falsely illuminate.

Electrical System — Wiring — Interior/Under Dash

Summary

On certain sport utility vehicles, water could enter the front floorboard area from openings in the side sill or upper dash area. This water could collect under the seat and cause electrical corrosion to occur in the harness connectors that contain the wiring for the seat belt pre-tensioner, side air bag impact sensor, and stop lamps.

Actions

Dealers will inspect the side sills and dash panel for openings that may allow water leakage into the vehicle cabin. In addition to sealing any openings that may be found, the wiring connectors will be inspected for signs of electrical corrosion. The floor harness will be replaced if it has any signs of water damage or electrical corrosion. Owner notification began June 23, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact Mitsubishi America at 1-800-222-0037 or Mitsubishi caribbean at 1-787-251-8715.

Documents (17)

• Manufacturer Notices(to Dealers,etc)
• Defect and Noncompliance Notice(Part 573)
• Fax Acknowledgement
• Other Recall Related Documents
• Quarterly Performance Report
• Owner Notification Letter(Part 577)
• Remedy Instructions and TSB
• NHTSA Originated Correspondence
• Manufacturer Notices(to Dealers,etc)
• Quarterly Performance Report
• Quarterly Performance Report
• Quarterly Performance Report
• Quarterly Performance Report
• Quarterly Performance Report
• Quarterly Performance Report
• Manufacturer Notices(to Dealers,etc)
• Quarterly Performance Report

Click a tab for more information.