Print this page

2.8

hardly worth mentioning
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
51,333 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

2009 Mercedes-Benz ML350 brakes problems

brakes problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2009 Mercedes-Benz ML350:

Unsubscribe any time. We don't sell/share your email.

2009 Mercedes-Benz ML350 Owner Comments

problem #3

Oct 272022

ML350 6-cyl

  • miles

A D V E R T I S E M E N T S

2009 Mercedes Benz ML350. Consumer writes in regard to NHTSA safety recall 22V-315.

- Danville, PA, USA

problem #2

Jan 012013

ML350

  • 40,000 miles
The contact owns a 2009 Mercedes-Benz ML350. The contact stated while driving at an unknow speed, the exterior light warning message was displayed on the instrument panel. The contact stated that the brake light bulb was replaced however, the failure recurred. The vehicle was taken to park place motorcars Mercedes-Benz dallas (113 lemmon ave, dallas, tx 75209; (214) 736-5753) where the contact was informed that the rear passenger's side brake light harness needed to be replaced. The vehicle was repaired however, the failure recurred on the driver's side and the contact was informed that the driver's side rear brake light wiring harness needed to be replaced. The vehicle was not yet repaired. The manufacturer was informed of the failure. The failure mileage was approximately 40,000.

- Dallas, TX, USA

problem #1

Sep 152017

ML350

  • 114,000 miles
My rear brake lines have corroded to the point that I lost my brakes. The fluid has leaked out. The car is not rusting or showing signs of rust or corrosion. Only the actual brake lines have rusted. It appears to be a defect in manufacturing. The lines should have had a protective coating or been covered in the exposed area to prevent excessive corrosion to the point the brake lines rusted thru and the vehicle lost it's braking ability. This happened while was in stop and go traffic so luckily nobody got hurt but if I was at a high rate of speed I would have lost my braking ability and it could have been much worse.

- Murrieta, CA, USA

Not what you are looking for?