Technical Service Bulletins (TSBs) for the 2003 ML320 are official communications between Mercedes-Benz & their dealerships that describe processes for troubleshooting or fixing certain common problems.
All vehicle manufacturers are required by U.S. law to make their TSBs available to the public.
XENTRY (MERCEDES): RATTLING NOISE COMING FROM THE AREA OF THE STEERING COLUMN TUBE SYSTEM, WHEN DRIVING OVER ROUGH ROAD AND WHEN ACCELERATING OR BRAKING, THERE WOULD BE CRACKING NOISES. MODELS 164, 251. NO MODEL YEARS LISTED. Read More »
XENTRY: RATTLING/THUMPING NOISES FROM THE AREA OF THE STEERING ON ROUGH ROADS OR WHEN DRIVING OVER ROAD UNDULATIONS. NO MODEL YEARS GIVEN. ALSO INCLUDED MODELS 168 AND 172. *JS Read More »
RATTLING/THUMPING NOISE ON ROUGH ROADS AND/OR KNOCKING NOISE WHEN MOVING STEERING IN BOTH DIRECTIONS ON ALL MODEL 164 AND 251 VEHICLES. MODEL YEARS UNKNOWN. *PE Read More »
MERCEDES: CHROME PLATING PEELING ON DECORATIVE CAPS ON THE STEERING WHEEL SPOKES, THIS IS DUE TO LESS THAN OPTIMAL ADHESION BETWEEN CHROME PLATING AND BASE MATERIAL. MODELS 164 AND 251. MODEL YEARS UNKNOWN. Read More »
XENTRY (MERCEDES): RATTLING NOISE COMING FROM THE AREA OF THE STEERING COLUMN TUBE SYSTEM, WHEN DRIVING OVER ROUGH ROAD AND WHEN ACCELERATING OR BRAKING, THERE WOULD BE CRACKING NOISES. MODELS 164, 251. NO MODEL YEARS LISTED. Read More »
XENTRY (MERCEDES): RATTLING NOISE COMING FROM THE AREA OF THE STEERING COLUMN TUBE SYSTEM, WHEN DRIVING OVER ROUGH ROAD AND WHEN ACCELERATING OR BRAKING, THERE WOULD BE CRACKING NOISES. MODELS 164, 251. NO MODEL YEARS LISTED. Read More »
MERCEDES: SEE DOCUMENT SEARCH BUTTON FOR OWNER LETTER. THE LOWER POWER STEERING HOSE AND CLAMP SHOULD BE REPLACE, UNDER EXTENDED WARRANTY, DUE TO POWER STEERING LEAKAGE FROM CONNECTION TO POWER STEERING COOLER. MODELS 1998-2003 163. Read More »
MERCEDES: SEE DOCUMENT SEARCH BUTTON FOR OWNER LETTER. THE LOWER POWER STEERING HOSE AND CLAMP SHOULD BE REPLACE, UNDER EXTENDED WARRANTY, DUE TO POWER STEERING LEAKAGE FROM CONNECTION TO POWER STEERING COOLER. MODELS 1998-2003 163. Read More »
MERCEDES: FOLLOWING FAULT CODES ARE ENTERED IN THE CONTROL UNIT AND DISPLAYED-FC5320 DRAIN VALVE:OPEN CIRCUIT OR INSUFFICIENT VALVE CURRENT IN MODELS SERIES 211, 219; FC5260 DRAIN VALVE OPEN CIRCUIT OR INSUFFICIENT VALVE CURRENT IN MODEL ... Read More »
SUSPENSION:FRONT:SPRINGS:AIR SUSPENSION:LINES AND FITTINGS
MERCEDES: FOLLOWING FAULT CODES ARE ENTERED IN THE CONTROL UNIT AND DISPLAYED-FC5320 DRAIN VALVE:OPEN CIRCUIT OR INSUFFICIENT VALVE CURRENT IN MODELS SERIES 211, 219; FC5260 DRAIN VALVE OPEN CIRCUIT OR INSUFFICIENT VALVE CURRENT IN MODEL ... Read More »
SERVICE BRAKES, AIR:SUPPLY:HOSES, LINES/PIPING, AND FITTINGS
MERCEDES BENZ: CHECK FOR INSTALLATION OF SPACER BETWEEN BRAKE AND FUEL LINE, INSTALL IF NECESSARY. THE SPACER BETWEEN THE BRAKE LINE AND FUEL LINE MAY NOT HAVE BEEN INSTALLED. Read More »
Engine diagnosis warning lamp lights up in instrument cluster, fault code U145400: "Implausible data were received from the ethanol sensor" Read More »
XENTRY (MERCEDES): ENGINE WARNING LAMP IS CURRENTLY ON OR WAS ON AND A DELAY FAULT OF THE CAMSHAFT ADJUST TO CURRENT OR STORED IN THE ENGINE CONTROL UNIT. MODELS 171, 203, 209, 211, 219, 221, 216, 230, 164, 251, AND 403. Read More »
CHECK ENGINE LIGHT ON / FAULT CODES FC1200 / FC1208 STORED IN ME-SFI CONTROL UNIT. MERCEDES-BENZ MODEL C230, C280, C350, SLK280, SLK350, CLK350, CLK550, E350, E550, CLS550, S600, AND SL550. EQUIPPED WITH M272 ENGINE OR M273 ENGINE. Read More »
Combination message: "Clean fuel filter" is displayed. The fault code 162500 (water level message - Bosch) or P226997 (water level message - Delphi) or 171600 (filter load - Bosch) is stored in the engine control unit. Read More »
MERCEDES BENZ: WORK ON PRESSURE REGULATOR VALVE (AS OF CD13, 1600 BAR SYSTEM). FUEL LOSS AT THE PRESSURE REGULATOR VALVE AND/OR POOR ENGINE RUNNING CHARACTERISTICS (SHAKES, KNOCKS, SURGES, CHANGES TO LIMP HOME MODE, POOR OUTPUT, POOR ... Read More »
MERCEDES: ENSURING UNOBSTRUCTED MOVEMENT FOR THE FUEL LEVEL SENSOR. WHEN INSTALLING THE LEFT OR RIGHT FUEL LEVEL SENSOR, IT IS ESSENTIAL FOR IT TO HAVE UNRESTRICTED, UNOBSTRUCTED MOVEMENT. Read More »
FUEL SYSTEM, OTHER:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS
MERCEDES BENZ: CHECK FOR INSTALLATION OF SPACER BETWEEN BRAKE AND FUEL LINE, INSTALL IF NECESSARY. THE SPACER BETWEEN THE BRAKE LINE AND FUEL LINE MAY NOT HAVE BEEN INSTALLED. Read More »
The COMAND unit does not start or the COMAND display remains dark. The COMAND unit cannot be operated. Note: The problem disappears after a lengthy idle period (>6h) or after interrupting the power supply (circuit 30). Read More »
XENTRY (MERCEDES): ENGINE WARNING LAMP IS CURRENTLY ON OR WAS ON AND A DELAY FAULT OF THE CAMSHAFT ADJUST TO CURRENT OR STORED IN THE ENGINE CONTROL UNIT. MODELS 171, 203, 209, 211, 219, 221, 216, 230, 164, 251, AND 403. Read More »
MERCEDES: AIR MATIC VISIT WORKSHOP DISPLAYED WITHIN INSTRUMENT CLUSTER. MODELS 164, 211, 219, 221 AND 251. INCLUDED 4MATIC, AMG (COMPRESSOR) AMG, BLUETEC AND WAGON. MODEL YEARS UNKNOWN. *PE UPDATED 9/18/09. Read More »
MERCEDES: BATTERY SYMBOL AND SERVICE REQUIRED (IN WHITE). FAULT MESSAGE IS DISPLAYED IF THE CHARGE LEVEL IS TOO LOW OR THE PARK PAWL ADDITIONAL BATTERY IS DEFECTIVE. Read More »
MERCEDES: AIR MATIC VISIT WORKSHOP DISPLAYED WITHIN INSTRUMENT CLUSTER. MODELS 164, 211, 219, 221 AND 251. INCLUDED 4MATIC, AMG (COMPRESSOR) AMG, BLUETEC AND WAGON. MODEL YEARS UNKNOWN. *PE UPDATED 9/18/09. Read More »
MERCEDES: BATTERY SYMBOL AND SERVICE REQUIRED (IN WHITE). FAULT MESSAGE IS DISPLAYED IF THE CHARGE LEVEL IS TOO LOW OR THE PARK PAWL ADDITIONAL BATTERY IS DEFECTIVE. Read More »
MERCEDES: STOP/TAIL LIGHT NOT ILLUMINATING WITH DTCS 9102, 9103, 9106, 9107, 9126, 9127 OR 9136. (VEHICLES WITHOUT LED TAIL LAMPS) *PE UPDATED 5/13/09. *PE UPDATED 4/20/11. REPAIR DOES NOT APPLY TO LED TAIL LAMPS. Read More »
Since 12/2012 (model 166) and since 06/2013 (model 242) the glass breakage loops are no longer in the side windows and rear window. Suitable interior protection ensures that the interior monitoring function continues to operate correctly. Read More »
XENTRY: OUTSIDE DOOR HANDLE NO LONGER RETURNS TO END POSITION. DUE TO A BENT PIN IN THE DYNAMIC BALANCER, THE SUPPORT SPRING OF THE BEARING BRACKET CAN SLIDE OUT OF PLACE OR BECOME UNHOOKED. MODELS 164, 251, 166, 204, 212. Read More »
Crease formation on genuine leather seat covers in vehicles with low mileage ??A?A? Objects left on the seats for extended periods of time (pressure marks). ??A?A? Objects wedged between the seat backrest and seat cushion (e.g. Read More »
MERCEDES: THE ELECTRICALLY FOLDING 3RD SEAT ROW MAKES NOISES WHILE FOLDING UP AND DOWN, OR THE FOLDING FUNCTION DOES NOT WORK AT ALL. A WARNING MESSAGE ABOUT LOCKING THE 3RD SEAT ROW MAY ALSO APPEAR IN THE DISPLAY. Read More »
MERCEDES: ELECTRONIC STABILITY PROGRAM (ESP), STABILITY CONTROL (SR). REFERENCES REVISED AND REFERENCE TO AF DELETED/SUPERSEDES DTB TB 42.45/42. ESP LAMP ON. CONTACT FAULT AT CONNECTION FOR ESP CONTROL UNIT MK25 (N47). Read More »
This Customer 1 Action has been initiated because certain mbrace subscribers were recently contacted by mbrace informing them that they need to have an i-button call performed to ensure their mbrace device has registered with the ... Read More »
