Technical Service Bulletins (TSBs) for the 2004 CL500 are official communications between Mercedes-Benz & their dealerships that describe processes for troubleshooting or fixing certain common problems.
All vehicle manufacturers are required by U.S. law to make their TSBs available to the public.
THE HIGH PRESSURE HYDRAULIC DISTRIBUTION HOSE OF THE ACTIVE BODY CONTROL (ABC) MAY DETERIORATE OVER TIME DUE TO EXCESSIVE EXPOSURE TO HUMIDITY AND HIGH TEMPERATURES. Read More »
BLEED BRAKE SYSTEM AND CHECK BRAKE SYSTEM FOR AIR ON THE SENSOTRONIC BRAKE CONTROL (SBC) SYSTEM USING STAR DIAGNOSIS. ALSO INCLUDES MERCEDES-BENZ 211 MODEL MY2004. *TT Read More »
PARKING BRAKE:CONVENTIONAL:MECHANICAL:LINKAGE AND CABLE
COOLANT HOSE AT THE BOTTOM RIGHT OF THE RADIATOR MUST BE CHECKED TO DETERMINE WHETHER THE TWO CATCHES OF THE COOLANT HOSE ARE LATCHED CORRECTLY. INSPECT LATCHING OF LOWER RADIATOR HOSE, REPLACE RADIATOR IF NECESSARY. Read More »
MERCEDES: REPLACING THE LONGITUDINAL MEMBER (LEFT AND RIGHT) BELOW THE MAIN FLOOR PANEL ON ALL MY 204 UP TO 12/31/07. (C300, C350, C300 4-MATIC, C63 AME). *PE Read More »
MERCEDES: REPLACING THE LONGITUDINAL MEMBER (LEFT AND RIGHT) BELOW THE MAIN FLOOR PANEL ON ALL MY 204 UP TO 12/31/07. (C300, C350, C300 4-MATIC, C63 AME). *PE Read More »
INSPECT TRANSMISSION PILOT BUSHING AT ELECTROCHYDRAULIC UNIT AND REPLACE IF NECESSARY. THE TRANSMISSION PILOT BUSHING MAY HAVE BEEN INSTALLED ON THE CONTROL UNITS WITH NON-TEMPERED SEALING RINGS WHICH MAY CAUSE A SMALL LEAK TO OCCUR. Read More »
INSPECT TRANSMISSION PILOT BUSHING AT ELECTROCHYDRAULIC UNIT AND REPLACE IF NECESSARY. THE TRANSMISSION PILOT BUSHING MAY HAVE BEEN INSTALLED ON THE CONTROL UNITS WITH NON-TEMPERED SEALING RINGS WHICH MAY CAUSE A SMALL LEAK TO OCCUR. Read More »
INSPECT TRANSMISSION PILOT BUSHING AT ELECTROCHYDRAULIC UNIT AND REPLACE IF NECESSARY. THE TRANSMISSION PILOT BUSHING MAY HAVE BEEN INSTALLED ON THE CONTROL UNITS WITH NON-TEMPERED SEALING RINGS WHICH MAY CAUSE A SMALL LEAK TO OCCUR. Read More »
THE PVC SEAM SEAL ON THE TRANSMISSION SUPPORT BRACKET MAY NOT HAVE BEEN PROPERLY APPLIED. INSPECT TRANSMISSION SUPPORT SEAM SEAL, RESEAL IF NECESSARY. *TT Read More »
Malfunctions of various control units and/or on-board power supply problems caused by water in the control unit tray under the driver/front passenger seat (dislocated, pinched or leaking condensation ... Read More »
INSPECT BOOT ON BOTH FRONT DOORS. THE BOOT AT THE DOOR CONNECTING TO THE A PILLAR MAY NOT HAVE BEEN CLIPPED CORRECTLY LEADING TO INSUFFICIENT SEALING. *NM Read More »
THE TRUNK LID SPRINGS COULD FAIL IN THE CLOSED TRUNK LID POSITION DUE TO EXTENSIVE EXPOSURE TO VERY HIGH TEMPERATURES. VOLUNTARY RECALL CAMPAIGN. COVER LETTER, RECALL CAMPAIGN BULLETIN AND LETTER TO OWNERS. Read More »
Crease formation on genuine leather seat covers in vehicles with low mileage ??A?A? Objects left on the seats for extended periods of time (pressure marks). ??A?A? Objects wedged between the seat backrest and seat cushion (e.g. Read More »
This Customer 1 Action has been initiated because certain mbrace subscribers were recently contacted by mbrace informing them that they need to have an i-button call performed to ensure their mbrace device has registered with the ... Read More »
