Technical Service Bulletins (TSBs) for the 2003 C240 are official communications between Mercedes-Benz & their dealerships that describe processes for troubleshooting or fixing certain common problems.
All vehicle manufacturers are required by U.S. law to make their TSBs available to the public.
THE HIGH PRESSURE HYDRAULIC DISTRIBUTION HOSE OF THE ACTIVE BODY CONTROL (ABC) MAY DETERIORATE OVER TIME DUE TO EXCESSIVE EXPOSURE TO HUMIDITY AND HIGH TEMPERATURES. Read More »
If the customer brakes sharply from a speed of > 30mph, without ABS intervention, there is a single cracking noise from the area of the ESP hydraulic unit Read More »
BLEED BRAKE SYSTEM AND CHECK BRAKE SYSTEM FOR AIR ON THE SENSOTRONIC BRAKE CONTROL (SBC) SYSTEM USING STAR DIAGNOSIS. ALSO INCLUDES MERCEDES-BENZ 211 MODEL MY2004. *TT Read More »
MERCEDES: REPLACING THE LONGITUDINAL MEMBER (LEFT AND RIGHT) BELOW THE MAIN FLOOR PANEL ON ALL MY 204 UP TO 12/31/07. (C300, C350, C300 4-MATIC, C63 AME). *PE Read More »
MERCEDES: REPLACING THE LONGITUDINAL MEMBER (LEFT AND RIGHT) BELOW THE MAIN FLOOR PANEL ON ALL MY 204 UP TO 12/31/07. (C300, C350, C300 4-MATIC, C63 AME). *PE Read More »
Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end). Heard once when changing from forward to reverse (and vice versa) Read More »
The presence of a quiescent current can have several causes. These are not always recognized and lead to an increased number of OK components being removed. Read More »
The COMAND unit does not start or the COMAND display remains dark. The COMAND unit cannot be operated. Note: The problem disappears after a lengthy idle period (>6h) or after interrupting the power supply (circuit 30). Read More »
Malfunctions of various control units and/or on-board power supply problems caused by water in the control unit tray under the driver/front passenger seat (dislocated, pinched or leaking condensation ... Read More »
Noise complaints when load on backrest frame changes. Affects the driver and front passenger seats. Also perform the remedial action if you are performing work on: - backrest frame - backrest cover or - guide rail of head restraint. Read More »
THE TRUNK LID SPRINGS COULD FAIL IN THE CLOSED TRUNK LID POSITION DUE TO EXTENSIVE EXPOSURE TO VERY HIGH TEMPERATURES. VOLUNTARY RECALL CAMPAIGN. COVER LETTER, RECALL CAMPAIGN BULLETIN AND LETTER TO OWNERS. Read More »
Crease formation on genuine leather seat covers in vehicles with low mileage ??A?A? Objects left on the seats for extended periods of time (pressure marks). ??A?A? Objects wedged between the seat backrest and seat cushion (e.g. Read More »
MODEL 203 (C) SERIES FROM PRODUCTION 8/1/01 TO 2/1/03 AND MODEL 209 (CLK) SERIES UP TO PRODUCTION 2/1/03; ESP VISIT WORKSHOP WITH FAULT CODE C1185. *PE Read More »
MODEL 203 (C) SERIES FROM PRODUCTION 8/1/01 TO 2/1/03 AND MODEL 209 (CLK) SERIES UP TO PRODUCTION 2/1/03; ESP VISIT WORKSHOP WITH FAULT CODE C1185. *PE Read More »
If the customer brakes sharply from a speed of > 30mph, without ABS intervention, there is a single cracking noise from the area of the ESP hydraulic unit Read More »
This Customer 1 Action has been initiated because certain mbrace subscribers were recently contacted by mbrace informing them that they need to have an i-button call performed to ensure their mbrace device has registered with the ... Read More »
