- January 13: Jeep Fires Cause Class Action Lawsuit news | 2 days ago
- December 24: More than 86,000 Jeeps Recalled Due to Backup Cameras recalls | 22 days ago
- December 17: Jeep Renegade Recall: Bumper Backup Light Problems recalls | 29 days ago
- November 26: 2024 Jeep Grand Cherokees May Show The Wrong Vehicle Speeds recalls | 50 days ago
- November 15: Jeep Power Steering Pump Fire Risk Causes Lawsuit news | 61 days ago
Jeep TSB #1810520
2020 Jeep Cherokee
TSB Document:
Affected Component: BACK OVER PREVENTION
- Summary
- Flash: Powertrain Control Module (PCM) Updates This bulletin involves reprogramming the PCM with the latest available software. The customer may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find one or more of the following Diagnostic Trouble Codes (DTCs):P20EE-00 - SCR NOx Catalyst Efficiency Below Threshold Bank 1 Catalyst 1. P24B2-00 - Particulate Matter Sensor Circuit Intermittent. Customers may also describe the following condition:Engine Start/Stop inoperative after previous software update. Remote start inoperative(South Korea vehicles only). Incorrect vehicle speed reported by the cluster when the driver changes the speed units. Undesirable pedal response in 4-LO mode. Selective Catalytic Reduction (SCR) system fault codes logged at higher vehicle speeds. Alternator load protection at idle. Check Engine Lamp or low battery indicator
Click a tab for more information.