- November 15: Jeep Power Steering Pump Fire Risk Causes Lawsuit news | 5 days ago
- November 14: Dodge Durangos and Jeep Grand Cherokees Recalled Over ABS Modules recalls | 6 days ago
- October 25: Jeep 4xe FORM Class Action Lawsuit Moves Forward news | 26 days ago
- October 1: Jeep 4xe Fire Recall Issued Following 13 Jeep 4xe Fires recalls | 50 days ago
- September 30: Jeep Wrangler 4xe Battery Problems Argued in Court news | 51 days ago
Jeep TSB #1801317
2017 Jeep Cherokee
TSB Document:
Affected Component: BACK OVER PREVENTION
- Summary
- Flash: Diagnostic and System Improvements This bulletin involves reprogramming the Powertrain Control Module (PCM) with thelatest available software. The customer may experience a Malfunction Indicator Lamp (MIL) illumination or notice the engine being too quick to shut down when coming to astop in Electric Stop Start (ESS) mode. Upon further investigation the technician may find the following DTCs set in the PCM memory:P0556 - Brake Booster Pressure Sensor Circuit Performance. U0428 - Implausible Data Received From Steering Angle Sensor Module. U1504 - Implausible Message Data Length Received From Steering Angle Sensor. C0501 - Left Front Wheel Speed Sensor Range/Performance. C0507 - Right Front Wheel Speed Sensor Range/Performance. C050D - Left Rear Wheel Speed Sensor Range/Performance. C0513 - Right Rear Wheel Speed Sensor Range/Performance. Erroneously set Wheel Speed Sensor DTCs listed above will not turn on the MIL by design but may be found during a vehiclediagnostic scan.Some customers may also experience the following condition:During an engine limp mode condition, the transmission remains in a fixedgear. In addition the following enhancements are included:Calibration update to allow the throttle body to be cycled while the engine isoff, for diagnostic purposes. Calibration update for ESS to allow the engine to remain running during a briefstop.
Click a tab for more information.