Effective June 2, 2008, Federal Motor Vehicle Safety Standard 110 (FMVSS 110) sets
a threshold for correcting load capacity information indicated on tire placards when the vehicle weight
has been increased before retail sale. This limit is the lesser of 1.5% of the Gross Vehicle Weight Rating
or 100 pounds. If the total added weight exceeds the lesser of the limit, a label (See Figure 1) must be
added to the driver-side B-pillar within 25mm (1 inch) of the original tire placard.
NOTE: Effective immediately, all ports will stop the installation of the Load Capacity Label when there
are no port accessories installed.
Effective June 2, 2008, Federal Motor Vehicle Safety Standard 110 (FMVSS 110) sets
a threshold for correcting load capacity information indicated on tire placards when the vehicle weight
has been increased before retail sale. This limit is the lesser of 1.5% of the Gross Vehicle Weight Rating
or 100 pounds. If the total added weight exceeds the lesser of the limit, a label (See Figure 1) must be
added to the driver-side B-pillar within 25mm (1 inch) of the original tire placard.
NOTE: Effective immediately, all ports will stop the installation of the Load Capacity Label when there
are no port accessories installed.
