CarComplaints.com Notes: The 1999 Honda Accord suffers from widespread transmission failure, subframe rust, engine shuts off while driving, & peeling paint. We recommend avoiding this model year like the plague.

The transmission begins slipping & eventually has to be replaced, typically soon after 100,000 miles & with a repair cost of over $2,000.

Subframe rust near the front passenger side wheel has become a problem recently, due to the poorly positioned A/C drain hose directly above that area. Repair cost to the subframe is over $2,000.

Engine stalling while driving in the 1999 Accord is typically caused by a defective ignition switch -- inexpensive to repair (under $200) but dangerous.

Peeling paint has also been an issue for these Accords. Most of the complaints are with darker paint colors -- especially green & blue.

10.0

really awful
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
0 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

1999 Honda Accord transmission problems

transmission problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 1999 Honda Accord:

Unsubscribe any time. We don't sell/share your email.

1999 Honda Accord Owner Comments

problem #1

Sep 282007

(reported on)

Accord

  • Automatic transmission
  • miles

A D V E R T I S E M E N T S

1999 Honda Accord stalling in all situations. Customer states that he had the vehicle repaired for a recall on the ignition switch, but the vehicle is still stalling out. The dealer asked the consume had the battery been replaced in the vehicle. The consumer stated the battery had been replaced. The dealer stated the problem was most likely the PCM computer lost some of its parameters when the battery was replaced and that the software would have to downloaded back into the onboard computer.

- Naugatuck, CT, USA

Not what you are looking for?