ABS failure at slow speeds-ABS tries to engage, brake is slow at first with noise and then ABS light appears and engages dangerous braking resets after turning off goes through it all again nest time you drive.

- Westmoreland, KS, USA

: the contact stated while the brakes were applied at speeds of less than 10 mph, the ABS engaged resulting in an increased stopping distance. The ABS light illuminated when the activation occurred. The brakes made a grinding noise and the vehicle pulled to the left. The vehicle was taken to a service dealer who replaced the passenger side wheel speed sensor. There is a NHTSA recall, #05V379000, regarding the anti-lock brakes. The VIN was not included in the recall. Updated 6/16/2006 -

- Monticello, MN, USA

Consumeer stated that vehicle locks up when ABS was applied and skid into uncontrollable stop. Also, rear end fishtails when accelerating.

- Rome, GA, USA

When applying brakes, there was an extended stopping distance. Contacted dealer and the dealer was not willing to do anything.

- Orlando, FL, USA

ABS brakes fail (vibrate/shudder/grind) during bumpy and turning conditions. They do not stop car. Dealer notified of problem and indicated that it is normal. I think brakes are defective since they do not stop car at all during previously mentioned conditions. For example, I recently went through a dip and put the brake pedal to the floor without stopping.

- South San Gabriel, CA, USA

On several occasions while driving with cruise control on, vehicle went from 70 mph to 40mph. ABS light illuminated, and brakes locked up. Dealer replaced ABS module.

- Clarksville, TN, USA

When depressing brakes pedal traveled to floorboard, causing extended stoping distance. Also, pulled hard to left and right. Dealer has been notified.

- Windsor, CA, USA