I have a 2018 GMC Sierra 1500 that I bought new in Oct of 2018 and it now has 15,756 miles on it and was still like new at the time of failure. On May 23rd I was driving the truck when the driver suspension suddenly had an structural failure (mostly the ball joint coming out of the control arm) causing the front right side of the suspension to collapse while driving. This caused the truck to go left of center into on coming traffic resulting in a traffic accident.

- Richmond, IN, USA

The contact owns a 2018 GMC Sierra 1500. The contact stated that while the vehicle was at an independent mechanic for an oil change, the independent mechanic performed a full inspection of the vehicle. The contact was informed that the CV axles were corroded, and the CV axles needed to be replaced. The vehicle was repaired. The contact was advised to report the failure to the dealer. The contact informed the dealer of the failure. The contact stated that the vehicle had been taken back to the dealer several times for repairs, including the transmission replacement, radiator replacement, and a full suspension replacement. The manufacturer was made aware of the failure. The failure mileage was approximately 93,555.

- Overland Park, KS, USA

The vehicle steering wheel shudders at speeds from 40-55mph. The steering wheel shudders at 2-second intervals and is constant between those speeds. At first, I thought it might be one of the safety systems. It is not. This is unsafe and GM should be held responsible.

- Pensacola, FL, USA

Noticed a scraping noise after new, recommended tires installed on my stock truck. Checked the door label to ensure correct tires installed, they were, returned to the tire facility and they recommended I ask a repair facility to investigate. Found that the tires are rubbing the upper control arm when fully turned left or right (both sides affected). Went online to discover that this is a common issue with the 2018 and similar GMC Sierra and Chevy Silverado trucks. This is a safety issue caused by a design deficiency. Two things can happen. One, the tire can fail. Two, the upper control arm could fail, causing the vehicle to be uncontrollable. This could be fixed by restricting the extreme left and right travel in the steering system or redesigning and replacing the upper control arm so it doesn-??t interfere with the tire. This is an unacceptable safety issue caused by a design deficiency and needs to be addressed by NTSB now.

- Alexandria, VA, USA

The contact owns a 2018 GMC Sierra 1500. The contact stated that while driving at an undetermined speed, the vehicle was shaking while shifting gears. The contact stated while shifting from four cylinders to eight cylinders, the rear-end was shaking violently. The hood latch warning light was illuminated. The vehicle was taken to the local dealer where it was diagnosed and determined that the tires needed to be replaced. The tires were replaced three times however, the failure persisted. The manufacturer was not contacted. The failure mileage was approximately 50,000.

- Sunapee, NH, USA

My truck has a severe vibration or shake extremely bad at 60mph and up.i have tried new tires, front end alignment, and several different shops have told me they don't know what it is drive shaft or axels

- Austin , TX, USA

Vehicle violently shakes at all speeds. Dealer blamed tires, I had new tires installed, still shaking. Dealer says "no problem found, operating as designed" truck is a nuisance to drive, shaking badly

- Lapeer, MI, USA

When driving the truck starts to rattle as is I was driving on a bumpy road. It is not continuously but id happens often

- Mesquite, TX, USA