- October 26: Recall: 2024 GMC Canyon Headlights Flicker recalls | 8 days ago
- October 12: GM Vortec Oil Consumption Lawsuit Dismissed news | 22 days ago
- September 28: GM Shift to Park Class Action Lawsuit Debated in Ohio news | 36 days ago
- September 27: Chevrolet Express and GMC Savana Cutaways Recalled recalls | 37 days ago
- September 23: GM Vortec Engine Lawsuit: Arbitration Motion Denied news | 41 days ago
GMC TSB #PIP5345
2014 GMC Sierra 1500
TSB Document:
Affected Component: EQUIPMENT ADAPTIVE/MOBILITY
- Summary
- This Preliminary Information communication provides information to the technician about being to achieve pre-load when setting up the pinion bearing pre-loads during reassembly of the 9.5/9.76 inch rear axles. Technician will need to use pinion gear install washer part number 11609638 onto the pinion shaft between the flange and nut. Tighten the pinion nut until you achieve 10 pound inch or 1.0 newton rotating torque. After the torque has been achieved back the nut off and remove the washer. Tighten the nut back down until you achieve 15 pound inch or 1.7 newton meters for used bearings or 20 pound inch 2.25 newton meters for new bearings.
Click a tab for more information.