Print this page

8.7

pretty bad
Typical Repair Cost:
$470
Average Mileage:
104,500 miles
Total Complaints:
3 complaints

Most Common Solutions:

  1. replace factory bolt with shorter bolt (2 reports)
  2. not sure (1 reports)
2008 Ford Fusion engine problems

engine problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2008 Ford Fusion:

Unsubscribe any time. We don't sell/share your email.

2008 Ford Fusion Owner Comments

problem #3

Jul 152014

Fusion SE 2.3L Inline 4

  • Automatic transmission
  • 127,000 miles

A D V E R T I S E M E N T S

Squealing noise from engine area. Idler pulley was leaning against engine block. Bolt that holds idler was broke. Took to Ford dealer replaced $30 pulley and bolt but cost $350 because the bolt had broken off in block.

- Kent H., Grand Island, NE, US

problem #2

Aug 152014

Fusion SE 2.3L Inline 4

  • Automatic transmission
  • 127,500 miles

Bolt broke a month later. Squealing again, took back to dealership. Replaced for free under warranty since used factory parts.

- Kent H., Grand Island, NE, US

problem #1

Aug 072013

Fusion L 2.5L

  • Automatic transmission
  • 59,000 miles

The tension pulley that holds the serpentine belt is held by a single screw. This piece of junk screw keeps breaking. I have fixed it three separate times. I have had it and now I am trading the car. I have fixed it three times in less than six months.

- Jose R., Orlando, FL, US

Not what you are looking for?