- November 5: $1.7 Billion Ford Truck Roof Collapse Verdict: Ford Gets New Trial news | 0 days ago
- November 4: Ford F-250, F-350 and F-450 Recalled Over Camera Issues recalls | 1 days ago
- November 4: Ford Mustangs Recalled For Instrument Panel Failures recalls | 1 days ago
- October 27: 2019 Ford Flex Backup Camera Problems Investigated investigations | 9 days ago
- October 26: California Ford Emissions Warranty Lawsuit Dismissed news | 10 days ago
Ford TSB #16-0041
2016 Ford F-250
TSB Document:
Affected Component: ENGINE AND ENGINE COOLING:ENGINE:DIESEL
- Summary
- PICKUP - 6.7L DIESEL ENGINE - RUNS ROUGH DURING EXHAUST REGENERATION PROCESS - BUILT ON OR BEFORE 2/23/2016 ISSUE Some 2015-2016 F-Super Duty 250-450 Pickup vehicles equipped with a 6.7L diesel engine and built on or before 2/23/2016 may exhibit a runs rough/misfire condition only during the exhaust regeneration process. This condition typically occurs on light throttle tip in between 64-113 Km/h (40-70 MPH) and will not set diagnostic trouble codes (DTCs). The concern may be intermittent and a knocking noise may be present during the concern. SERVICE PROCEDURE 1. Reprogram the powertrain control module (PCM) to the latest calibration using Integrated Diagnostic System (IDS) release 99.03 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also be obtained at www.motorcraftservice.com 2. Did the customer indicate the message center displayed a Cleaning Exhaust Filter message prior to the concern? a. Yes - proceed to Step 3. b. No - proceed to Step 6. 3. Remove the left cylinder head. Refer to Workshop Manual (WSM), Section 303-01. 4. Replace all eight (8) exhaust valves and valve seals. Refer to WSM, Section 303-01. (Figure 1)
Click a tab for more information.