Driver side door and front fender don't align proper, looking at this gap and bump between fender and door, feel like this brand new truck has been in some sort failed body repair. Fritt's Ford at Riverside, CA look at it, recommended leave as is, because moving/re-align the fender or the Door might lead Driver side door Not close/seal properly. Lesson learned, always carefully inspect your New truck, inspect/pick up new truck during day time, take as much time as possible.
I had the factory bed liner installed. I do not like it at all. If I am in the box of the truck I can see the ground where the panels meet on the floor of the bed. I had a linex on my last truck and the bed was sealed. Just got back from fishing and everything in the bed was covered in dust . I had mentioned this complaint on my ford survey but they had not contacted me.
I would not recommend getting the factory liner installed. VERY DISAPPOINTED.
DRIVER SIDE FRONT DOOR:
1. Approx. 2’ in from front edge under mirror – Panel wave/ripple.
2. Approx. 26-3/8†from front edge & 2-7/8†up from lower body line – Fish eye/dirt under/in paint.
3. Under door handle two places - indents/ripple panel, flexing where door handle is located.
DRIVER SIDE REAR DOOR:
1. Top of door panel under glass dirt under paint.
2. Approx. 3’ from front edge of door between black filler and upper body line is a dent.
3. Body panel edge not aligned front to rear door.
4. Approx. 3’ in from front door edge from upper body line to lower body line the door panel is concaved/wavy, rippled.
5. Same at rear edge of door panel.
DRIVER SIDE BED:
1. Front to rear of the box above the upper body line is wavy/ripples.
2. Approx. 48†back from the front of the box above the upper body panel the body panel seams protrude.
3. From the front of the box to the wheel well below the lower body line the paint is rough.
PASSENGER FRONT FENDER:
1. Approx. 23†from door edge & 1’ down there is a pointed protrusion in the fender.
PASSENGER SIDE FRONT DOOR:
1. Approx. 2’ from front edge below mirror above the upper body line the panel is wavy.
2. Approx. 26†back from front edge & 3†down from upper body line the door panel is wavy.
3. Under door handle two places - indents/ripple panel, flexing where door handle is located.
4. Door does not close flush with rear door.
PASSENGER SIDE REAR DOOR:
1. The door is out of alignment - The gap at front edge to front door is Approx. 3/8†and the gap from the rear door edge to cab is Approx. 1/8â€
2. Wavy door panel under black piller cap.
3. Above upper bodyline Approx 1-1/2†from front edge of door - Fisheye or dirt in paint.
4. Approx. 3’ in from front door edge from upper body line to lower body line the door panel is concaved/wavy,rippled.
PASSENGER SIDE BED:
1. Front to rear of the box above the upper body line is wavy/ripples.
2. Approx. 4†back from the front edge down 1†– Fish eye/dimple in paint.
3. Approx. 48†back from the front of the box above the upper body panel the body panel seams protrude.
DRIVER SIDE ROOF ABOVE REAR PASSENGER DOOR:
1. Rough paint on roof above rear passenger door.
BED TO INTERIOR SIDE PANELS:
1. The interior side and front box panels are not mated properly or sealed to the bed bottom, photo represents typical around all three panels to box.
- 2016-f150,
Tacoma, WA, US
Search CarComplaints.com for these popular complaint phrases...
A D V E R T I S E M E N T S
Driver side door and front fender don't align proper, looking at this gap and bump between fender and door, feel like this brand new truck has been in some sort failed body repair. Fritt's Ford at Riverside, CA look at it, recommended leave as is, because moving/re-align the fender or the Door might lead Driver side door Not close/seal properly. Lesson learned, always carefully inspect your New truck, inspect/pick up new truck during day time, take as much time as possible.
- pw924, corona, California, United States