This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.
So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.
I was driving on freeway when a car that was traveling in an excess of 80+ miles and rear-ended my 2002 Ford F 150. My truck was totaled and my drivers seat back frame broke from right side and none of my airbags deployed. I ended up in the hospital for 3 days. I had a concussion, neck injury, knees and re-injured my back. I was lucky to be alive.
Both locking pawls on manual seat adjustment mechanism do not lock into place when seat adjustment lever is released. One or the other pawl locks into place and a large amount of shifting force is then required to move the second pawl into a position where it will engage. This would only be a minor inconvenience if it were not for the seat belt configuration of this vehicle. This seat belt attaches not to the sub floor or pillar but to the seat itself. If (as has happened many times to me) you are under way and reposition the seat, you may not realize the seat is not safely locked into position. If you were then involved in an accident the strain on the engaged pawl might be beyond design parameters. When the unengaged pawl, traveling to its next locked position under the forces of the accident, meet the mass of the occupant and seat, the shear forces may cause failure of the pawl allowing the occupant and his /her seat to be uncontrolled during an accident. This could result in unnecessary injury to the occupant. An air bag SRS could exacerbate this circumstance causing escalating injury(s).
My company purchased this truck for me to work in \ with to perform my job. The seat is too high. My eyes are level with the top of the windshield and it's irataiting to look thur the colored part in the top part of the windshield. Seating this high up also causes the rear view mirror to block my vision in this ditection. I checked into getting a power seat but it does not go any lower. The dealer says is he checking this out. I also have two other employees with this same problem. We checked the seats in the 2001 and 2000 trucks and found that the high seats started in 2001. The seats in the 2000 truck were just right. Need some help with this or is it just us? thank you.
A D V E R T I S E M E N T S
- Arbuckle, CA, USA