Is your defective Ford Escape actually a LEMON?

Find out in 30 SECONDS or less if it qualifies for a REFUND or a CASH SETTLEMENT.

Print this page

10.0

really awful
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
0 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

2021 Ford Escape seat belts / air bags problems

seat belts / air bags problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2021 Ford Escape:

Unsubscribe any time. We don't sell/share your email.

2021 Ford Escape Owner Comments

problem #4

Oct 162023

Escape

  • miles

A D V E R T I S E M E N T S

When buckling up the seat belts in the back seat of my car- they do not register on the screen. I get a message that says 'rear belt monitor fault service required'

- Azle, TX, USA

problem #3

May 182023

Escape

  • miles
The car shakes while the car is in idle. The car displays an illuminated crossed out child car seat and the word -??on-??. These two alerts do not turn off. Even though there is no one seated in a back and two adults are seated in the front seats. It also leaks fluid. I have an appointment with a ford dealer this Tuesday and I already contacted the ford corporate office. #CA********

- Montebello , CA, USA

problem #2

Sep 072022

Escape

  • miles
"PASSENGER SIDE SEATBELT PRETENSION AND RETRACTOR ASSEMBLY INTERNALLY FAULTED:" This caused the seat belt light to be illuminated. This was repaired free of charge by the dealership.

- Houston, TX, USA

problem #1

Jan 032022

Escape

  • miles
I rented this Ford Escape from Avis this month and ran into what could have been an incredibly dangerous safety issue due to a massive oversight in the car's design. I installed a small booster seat in the passenger side back seat for my 10 year-old son. He got in the seat and attached his seat belt, which he has done hundreds of times before in our own car. About 1 hour into a 2-hour freeway trip, a notification went off on the dashboard, telling me that a seat belt in the back had come undone. My son tried frantically to reattach the buckle but was unable. I had to exit the freeway and park on the side of the road. When I tried to reattach the buckle, I saw why there was a problem: He had inserted the buckle into the CENTER receptacle, not the passenger-side one. The receptacle didn't click, as it was probably designed not to do, but because the metal of the buckle has a slight angle to it, there was enough tension for it to temporarily hold. However even a minor accident could have been fatal because my son wasn't property strapped in. There are several issues here. First, the dash indicator should have been designed to tell me that there was weight on the right rear seat but no buckle was attached to that receptacle. Second, the center receptacle did not immediately reject the right-most buckle; instead, the bent angle of the buckle's metal temporarily held it in place and made my 10 year-old believe he was strapped in. Finally, the receptacles themselves have no play from side-to-side. This, plus the angle of the buckle's metal, means that when a booster seat is installed, there is not enough room to fully attach the buckle into the receptacle without exerting a LOT of force to push the receptacle to the left. I can't imagine the buckle can be attached at all with a larger child seat. The image I attached shows why this is; attaching a car seat requires exerting enough force to bend the metal holding the receptacle in order to attach the buckle.

- Valley Village, CA, USA

Not what you are looking for?