Print this page

10.0

really awful
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
0 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

1996 Ford Crown Victoria suspension problems

suspension problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 1996 Ford Crown Victoria:

Unsubscribe any time. We don't sell/share your email.

1996 Ford Crown Victoria Owner Comments

problem #16

Jul 061999

Crown Victoria

  • miles

A D V E R T I S E M E N T S

Front suspension components have failed (tie rods, control arms).

- San Antoni, TX, USA

problem #15

Sep 241998

Crown Victoria

  • miles
Left front ball joint failed.

- Blackwood, NJ, USA

problem #14

Sep 241998

Crown Victoria

  • miles
Left front ball joint failed.

- Blackwood, NJ, USA

problem #13

Sep 241998

Crown Victoria

  • miles

A D V E R T I S E M E N T S

Left front ball joint failed.

- Blackwood, NJ, USA

problem #12

Jun 061998

Crown Victoria

  • Automatic transmission
  • miles
While driving at highway speeds, making a turn on a smooth curve, vehicle just straightened out unexpectedly. Pitman arm and control arm were relaced at owner's expense.

- Edina, MN, USA

problem #11

Jan 211998

Crown Victoria

  • miles
Vehicle has had the front ball joint and inner tie rods replaced. Recall was ordered on vehicle.

- Plainwell, MI, USA

problem #10

Jul 071998

(reported on)

Crown Victoria

  • miles

A D V E R T I S E M E N T S

Ball joint failure on two police vehicles (1996 Crown victorias).

- Coos Bay, OR, USA

problem #9

Jul 011998

(reported on)

Crown Victoria

  • miles
Noise from the front ball joint area.

- Ponce Inlet, FL, USA

problem #8

Jul 011998

(reported on)

Crown Victoria

  • miles
Noise heard from the front ball joint area.

- Ponce Inlet, FL, USA

problem #7

May 011998

Crown Victoria

  • Automatic transmission
  • miles
Lower control arm/ball joints failed causing vehicle to feel loose in the front end. (qcaw)

- Amherst, NY, USA

problem #6

May 011998

Crown Victoria

  • Automatic transmission
  • miles

A D V E R T I S E M E N T S

Lower control arm/ball joints failed, causing front end to feel loose. (qcaw)

- Amherst, NY, USA

problem #5

Jun 131998

Crown Victoria

  • Automatic transmission
  • miles
Police cruiser: Slowing down. Wheel goes into wheel housing (fender). This caused vehice to drop. Mechanic noticed grease fitting was omitted. This caused the ball joints to fall out.

- St Louis, MO, USA

problem #4

Jun 131998

Crown Victoria

  • Automatic transmission
  • miles
Police officer's vehicle was slowing down when the wheel went into wheel housing area (fender). Vehicle collapsed downward. Mechanic noticed that grease fitting was missing & balljoints fell out.

- St Louis, MO, USA

problem #3

Jun 161998

Crown Victoria

  • Automatic transmission
  • miles
Police officer's vehicle has ball joints falling out. Mechanic had noticed the grease fitting was missing. This could cause the wheel to go into the wheel housing (fender).

- St Louis, MO, USA

problem #2

Jun 131998

Crown Victoria

  • Automatic transmission
  • miles
Police officer was slowing down when wheel went into fender area (wheel housing), causing vehicle to be inoperable. Mechanic noticed that grease fitting was omitted. This caused the ball joints to fall out.

- St Louis, MO, USA

problem #1

Jun 201996

Crown Victoria

  • miles
Ball joint connecting pitman arm to drag link (track rod) fell off.

- Neosho, MO, USA

Not what you are looking for?