Print this page

10.0

really awful
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
0 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

1995 Ford Crown Victoria suspension problems

suspension problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 1995 Ford Crown Victoria:

Unsubscribe any time. We don't sell/share your email.

1995 Ford Crown Victoria Owner Comments

problem #7

Apr 012002

Crown Victoria

  • miles

A D V E R T I S E M E N T S

The front suspension ball joints were replaced at my cost. They had started squeaking and were worn badly. My mechanic suggests that the entire front suspension be rebuilt for safety because Ford does not have grease joints on any these parts. When the horn button was pushed for longer than a few seconds, it used to blow the fuse. The last time it did this, it also disabled the cruise control. I was told by my mechanic the only fix was to replace the steering column where these wires were shorting together internally.

- Trenton, TN, USA

problem #6

Feb 011999

Crown Victoria

  • miles
Front suspension was popping and getting tight. Ball joints broke into two pieces, and the front of vehicle dropped down, totally disabling the vehicle.

- Ok, OK, USA

problem #5

Mar 282000

(reported on)

Crown Victoria

  • miles
While driving ball joints/pitman arm malfunctioned. Was no prior warning. Vehicle was serviced by dealership before problem happened. Steering linkages were defective after having vehicle checked.

- Georgetown, MA, USA

problem #4

Mar 242000

Crown Victoria

  • Automatic transmission
  • miles

A D V E R T I S E M E N T S

While driving at 5 to 10 mph front passenger's side wheel came off due to ball joints coming apart. Dealer has been contacted.

- Warsaw, MO, USA

problem #3

Aug 101999

Crown Victoria

  • miles
Design of ball joints causes them to not have greased insert which resulted in ball joint failing collapsing the left front end of vehicle and puncturing the left front tire. Nlm

- Norman, OK, USA

problem #2

Jun 241996

Crown Victoria

  • Automatic transmission
  • miles
Police car, pitman arm/ball joint let go, resulting in steering problems, in for repair.

- Houston , TX, USA

problem #1

Jul 021996

Crown Victoria

  • Automatic transmission
  • miles
Four police vehicles are experiencing failures w/pitman arm/ball joint separating.

- Chilli Cothe, OH, USA

Not what you are looking for?