10.0

really awful
Crashes / Fires:
2 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
13,172 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

1995 Dodge Ram Van 3500 brakes problems

brakes problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 1995 Dodge Ram Van 3500:

Unsubscribe any time. We don't sell/share your email.

1995 Dodge Ram Van 3500 Owner Comments

problem #4

Jun 022002

Ram Van 3500 4WD

  • 52,688 miles

A D V E R T I S E M E N T S

Rusted brake lines caused brake fluid leakage.

- Prospect, KY, USA

problem #3

Aug 132002

Ram Van 3500

  • Automatic transmission
  • miles
While driving and when brakes were applied they did not hold, pedal went all the way to the floor, consumer stated the vehicle coasted through a red light through a busy intersection, this was caused by a hole in the brake line, which was the result of the way the brake line was assembled.. consumer stated the 4X4 did not work, the tire blew out, there was a water leak and the carpet had to be replaced twice, the rear window was replaced, the rear brakes never worked, the radio was inoperative, the hood light flickered while driving, and also vehicle experienced transmission problems.

- Huntley, IL, USA

problem #2

Nov 132001

Ram Van 3500 Diesel

  • Automatic transmission
  • miles
When brakes were applied pedal went to the floor, resulting in extended stopping due a defective brake line..

- Beauerton, OR, USA

problem #1

Feb 081999

Ram Van 3500 4WD

  • miles
The brake hose failed because of a design defect. The bracket that is part of the hose assembly causes a bend in the hose that forces the hose to contact the wheel wearing a hole in the hose. The replacement hose is designed to eliminate this bend. The right hose is designed the same way. Apparently, Chrysler found this problem and corrected it but did not recall the defective parts.

- Ballston Lake, NY, USA

Not what you are looking for?