This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.
So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.
While driving 75 mph the consumer lost all steering and brake power preceded by a loud noise coming from the engine. The technician serviced the vehicle and replaced the broken engine crankshaft. The engine failed because lubrication failed to reach the front two piston rods. The other six piston rods and bearings showed no lubrication problems.
Consumer stated while driving, and without prior warning the oil pump went out causing the engine to freeze which in resulted in loss of power. Consumer has contacted the dealer,
This truck has had a noise in the engine shortly after I purchased the truck. It has been downhill since then, I casn get all the service reports on file at bill abbott. The truck is now at cummings midwest power co. In bloomington il for anouther problem they have the head off and checking it for a problem also the crankshaft seal leaks oil this isthe second engine in this truck. I would really like to see if I could exchange this truck for a like one as I can't trust this truck. Thank you. Glenn thomas.
Oil breather cap is located in front of engine fan, forcing oil fumes into vehicle. Vehicle was sent to dealer shop on three occasions, and problem still reoccurring. Provide any further information.
June 1,2000 (2958ml) engine starts pinging, driver side window thumps when rolling up & down. July 21,2000 (6840ml) engine still pings, knocking sound under vehicle, thumping in window still present, oil pressure falls while driving. July 31,2000 (7509ml) engine still pings, knocking under vehicle still present.left cylinder head cracked, #2 cylinder replaced. Sept. 12,2000 (9420ml) engine still pings, knocking under vehicle still present, oil pressure still falls while driving, thumping in window still present, final repair attempt. Dec. 7,2000(14128ml) had to have crankshaft, rod bearings, main bearings, #4 cylinder rod and piston, oil pump repalced.returned on 12/14/00. Dec. 15,2000 (14169ml) no oil pressure. Had to have oil sending unit, oil pump, & screen replaced..
A D V E R T I S E M E N T S
- Fanwood, NJ, USA