Was driving vehicle it stalled. Consumer tried to restart vehicle, but vehicle would not restart.

- Bay City, MI, USA

Engine caught on fire without warning.

- Venice, FL, USA

I have a 1996 Dodge Ram van 2500 with a 3.9 liter engine in 117000 miles I had to have 2 timing chains installed and now it is on its 3rd timing chain why?

- Dale City, VA, USA

Dodge dealerships received a notice not to use frame filters as they explode and throw fragments of the filter into the engines. Dodge owners were never warned. Fram advertisements say they have the best filters. Evidently, this has happened many times before according to mechanics and owners and the web. Our time warranty ended 01/02, but the mileage isn't even close. We bought the big Dodge thinking it would be the last truck we purchase since we are in our 70's. the cummings diesel engine should run 300,000 miles, so 38,000 is nothing in comparison. We need some kind of help with this problem. Thank you, [xxx] & [xxx]. parts of this document have been redacted to protect personally identifiable information pursuant to the Freedom Of Information Act (FOIA), 5 U.S.C. 552(B)(6).

- Tygh Valley, OR, USA

While driving, consumer discovered that crankshaft was misaligned and knocked bearings out of the rods. Dealer installed remanufactured engine in truck at 54,000 miles, the remanufactured engine had a knock in it from day one of installation, consumer took truck back to dealer, dealer replaced pan and bearings.

- Vanben, AR, USA

While changing the motor oil, I noticed the rear of the motor wet with oil. Traced oil leak via mechanic back to the rear of the heads on both sides. Losing approx 1/2 qt of oil between changes.

- Randolph, NJ, USA

While driving vehicle completely stopped without warning, none of gauges went out. Took vehicle to dealer, and they said it was sludge that build up. 10 months later, campshaft went out.

- Deltona, FL, USA

Original failure took place on Nov 26, 1997. The oil light came on and oil pressure droppped to zero. The oil pump was replaced under warranty. Then, on Jan 21, 1999 the same scenario happened again. This time the oil pump, connecting rod, crankshaft and gaskets were replaced at my expense as the vehicle was no longer under warranty nor were the parts that had been replaced. Finally, on February 14, 2000 the entire scenario took place again. The oil light came on and oil pressure dropped to zero. It appears that the oil pump will agin need to be replaced. At this point, the dealership is trying to say it is a lack of maintenance and should be repaired at my expense. My concern is that the vehicle has been maintained and that after 3 failures there is a definite problem with the vehicle. The vehicle is currently at the previously mentioned dealership awaiting repairs and the response from Chrysler Corp as to whether or not they will do so at their expense. Any help you can provide would be greatly a

- Austin, TX, USA

Initial transmission problem started @ 38000 just out of warranty. Dealer said they couldn't help. I never thought of contacting manufacturer. Trans. Diagnosis complete at 72500 mis, dealer say rebuild, R+R at 89300mis. Brake mastercylinder lid was leaking causing insufficiet fluid level lead to pad and shoe failure. Transmission failure led to lifter failure in the engine. Trans would long shift putiing strain on engine causing a higher rev. Ultimately weakening 2 lifters. I am now hearing a noise and feeling jolts on the steering wheel turning left. Problem is unknown at this time.

- Oakford, PA, USA

Driving at approximately 70 mph engine piston rings, failed causing vehicle to stall on the highway.

- Walnut, CA, USA

The engine oil pan had burned due to a lack of oil. Vehicle had stopped running. Took to dealer. Mechanic had to replace old engine bearings with new engine bearings.

- Detroit, MI, USA

There are 2 extra pieces on camshaft on engine. No plate (lifter keeper). This causes the engine to sound/run like a diesel. Rockale assembly rods cut into camshaft, leaving 1/2 groove. Taken to dealer for repairs. The mechanic change oil & filter which was full of shaving 3 times but the engine not right..et.

- Destrehan, LA, USA

Cylinder head cracked resulting in failure.

- Riverside, CA, USA

Valve cover gaskets leak.

- Mont Belvi, TX, USA

Timing belt failed.

- Mont Belvi, TX, USA

Gasket split.

- Canby, OR, USA

Oil was leaking.

- Canby, OR, USA

Outer ring of balancer came apart, causing water pump/water hose to break and blow out front left tire.

- Garland, TX, USA

Crankshaft sensor failed.

- Bearden, AR, USA

During vehicle operation at 10 mph the crankshaft pulley& belt fell off, causing a loss of power steering. The vehicle was taken to the dealer where it was repaired. The same problem took place a 2nd time.

- Toledo, OH, USA