When brakes are applied they go to the floor and do not hold. The master cylinder has been replaced 3 times. This is a reoccuring problem, and the consumer is afraid for her family. Consumer states that this problem occurs about every 10K to 12K miles. Consumer feels unsure/unsecure about this vehicle and feels that Chrysler needs to address this matter before someone is possibly killed.

- Huston, TX, USA

When applying brakes, only half of brakes were appyling pressure to rotors. Consumer performed repairs to vehicle. The ridge in casting keeps the caliper from floating freely applying pressure only to the piston side of the caliper.

- Zion, IL, USA

A rapid wear of pads and rotors.

- Louisville, KY, USA

Oil leaks from rear axle and causes rear brakes to malfunction.

- Williamstown, NJ, USA

When applying the brakes under normal conditions, the vehicle pulls to either the right or left side. *akthe front brakes overheated causing the vehicle to pull while driving.

- Sisters, OR, USA

While driving on highway put on brakes lightly and vehicle pulled to the left and jerked to the other lane. *akthis problem occurs with each braking since about 45000 miles, the consumer has been unable to get it repaired, sometime the pulling while braking is mild yet sometimes it is severe, the tires were changed but there was no effect on the braking.

- Whitehall, MT, USA

Brake system failure caused caliper, pad, drum and shoe failed.

- Riverside, CA, USA

While driving at highway speeds, brakes are soft wehn applied, and the pedal goes straight to the floorboard, causing vehicle to not stop. Consumer had to keep his foot down on the brakes until the vehicle came to a stop.

- Greeley, CO, USA

On several occasions the brakes / calipers / pads / rotors failed.

- Yucaipa, CA, USA

When applying the brakes steering wheel is pulled out of drivers hands because the vehicle violently pulls to the left.

- Pleasanton, CA, USA

Premature wear of the brakes causes them to overheat, and makes it difficult to stop vehicle. Dealer has been contacted.

- Brick Town, NJ, USA

Brakes overheat and pull hard continually.

- Reno, NV, USA

Brakes do not provide adequate braking during abrupt stops. Adjusted rear brakes but that did not fix the problem.

- Great Mill, MD, USA

While driving about 5 mph and stepping on the brake pedal, brakes make a grinding noise metal to metal and lock up the front tires. When this happens could lose control of vehicle.

- Bakerfield, CA, USA

Extended stopping distance.

- Snellville, GA, USA

When the brakes are applied the vehicle sways to the left or to the right. Also, experiences extended stopping distance. The dealer has been notified four times.

- Snellville, GA, USA

When applying the brakes the vehicle pulls to the left or right. Dealer has seen vehicle twice and still no solution.

- Triangle, VA, USA

When applying the brakes under any circumstances, the truck swerves to the left or right, more to the left. The dealer has attempted to repair the problem (6) times. Problem still exists.

- Sunnyvale, CA, USA

Vehicle pulls when brakes applied.

- Alton, NH, USA

When applying the hydraulic brakes, in type of weather or speed, the vehicle is pulling to the right. The right pulling has been corrected but the vehicle now pulls to the left.

- Grand Junction, CO, USA