On any type of road surface, when braking in an emergency situation, the brake pedal goes to the floor and the vehicle does not stop. Condition almost caused several crashes. Front brake pads was replaced at 40,000 miles. Problem still exist.

- Spring, TX, USA

While trying to stop vehicle and putting on brakes the vehicle wll pull hard in any direction, causing driver to go off the road. Brakes have been replaceed on 4 occasions, however problem still persisted, Chrysler is replacing vehicle.

- Pinetop, AZ, USA

Anti lock brakes failed, causing accident.

- Abita Springs, LA, USA

When applying the ABS brakes, the right side brakes locked up, causing the vehicle to flip over.

- Ogden, UT, USA

When applying ABS brakes vehicle shakes violently/pulls to the left.

- Victorville, CA, USA

Vehicle experienced a transmission overheating problem. Also, vehicle pulled to the left upon braking/front end misalignment pulled vehicle to the right.

- Brookline, NH, USA

ABS brake failure, when brakes are applied vehicle pulls to the right, and when coming to a stop, brakes lock up/jerks the vehicle, causing a loss of control.

- Malakoff, TX, USA

ABS brake failure, made a loud noise, also, replaced disc pads/rotoes and calipers.

- Edge Water, MD, USA

While driving the brakes would pull and vibrate. Also, the brakes made a loud noise without applying the brakes. Dealer replaced brakes every 6000 miles.

- Tucson, AZ, USA

ABS brakes failed, applied the brakes and the pedal goes the floor, loss of effectiveness, pedal fade, S. in for replacement of master cylinder, bleeding the lines.

- Orlando, FL, USA

When braking pedal sometimes goes to floor, vehicle pulls to left, no accidents. Dealer aligned wheels, replaced shim pack, various speed.

- Fairburn, GA, USA

When applying the brakes on normal road condtions the pedal went to the floor and vehcile hit a curb. The system has ABS.

- Los Angeles, CA, USA

Antilock brakes failed.

- Bakersfield, CA, USA

Antilock brakes inoperative.

- Chillicothe, OH, USA

ABS brakes make vehicle pull to side as a result of of recent repairs.

- Freemont, CA, USA

The vehicle's ABS braking system failed at 25 mph, causing the vehicle to skid and resulting in an accident. Previously manufacturer replaced the rotors, brake pads and determined the wheel cylinder was leaking.

- Chandler, AZ, USA

Owner has ABS brakes, she states that the pedal goes to the floor when brakes are applied and that there is noticeable pedal fading when brakes are used.

- Tucson, AZ, USA

Anti-lock brakes defective; when applied, truck spins around, according to dealer, ABS do not seem to be working, hard to stop, lock up on wet pavement, no accidents, speed from 30 to 45 mph.

- Newport News, VA, USA

Owner has ABS brakes, he states that when he uses his brakes vehicle pulls to the right, owner is concerned about this problem.

- Pine, CO, USA

While driving at various speeds and applying the ABS brakes, rear brakes do not catch, front brakes work only, vehicle continues to experience extended stopping distance before stopping fully. Taken to dealership again.

- Delano, CA, USA