5.0

fairly significant
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
19,630 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

2001 Dodge Neon body / paint problems

body / paint problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2001 Dodge Neon:

Unsubscribe any time. We don't sell/share your email.

2001 Dodge Neon Owner Comments

problem #5

Dec 162006

Neon 4-cyl

  • miles

A D V E R T I S E M E N T S

Leaky trunk and back seat.

- Mississauga, 00, USA

problem #4

Oct 012006

Neon

  • miles
Trunk leaking badly in rain, caused mold to grow in the car with a very bad odor.

- Redford, MI, USA

problem #3

Jan 062006

Neon

  • 68,148 miles
The seal around the trunk lid is leaking. There was a large puddle in my trunk from rain water, it leaked underneath into the spare tire holding area, then into the back seats and carpet in the car. The water could not be completely removed, and there is mold in the car now. Mold is a health hazard. The seal is faulty.

- San Ramon, CA, USA

problem #2

Oct 192004

Neon 4-cyl

  • Automatic transmission
  • 30,000 miles
The seal around the trunk of the vehicle leaked, creating a molding smell around the trunk and rear seating of the vehicle. Also, the buckle of the seat belt was defective. The latch will not stay in the buckle. The consumer was told that the seat belt was not under warranty, and wanted the consumer to pay for the seat belt to be repaired. (the buckle had come out of the inner seat) the consumer felt that the damage was due to water and mold damage.

- Middletown, NY, USA

problem #1

Aug 012001

Neon

  • Automatic transmission
  • miles
Trunk lid will not stay in the upright position, springs do not work, there is no tension at all. When in upright position lid will and has fallen on consumer while putting something in trunk.

- Piney Point, MD, USA

Not what you are looking for?