10.0

really awful
Crashes / Fires:
1 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
40,526 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

1999 Dodge Dakota suspension problems

suspension problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 1999 Dodge Dakota:

Unsubscribe any time. We don't sell/share your email.

1999 Dodge Dakota Owner Comments (Page 6 of 12)

« Read the previous 20 complaints

problem #124

May 092004

Dakota 4WD 8-cyl

  • Automatic transmission
  • 68,000 miles

A D V E R T I S E M E N T S

While driving 35 mph or more vehicle wandered while in motion. Vehicle was taken to the dealer, who informed the consumer that the upper/lower ball joints needed to be replaced on both sides.

- Norton Shores, MI, USA

problem #123

May 102002

Dakota 4WD 6-cyl

  • Manual transmission
  • 40,000 miles
Had ball joints replaced once already and thy need to be replaced agian. First time on my extended warranty, this time will be at my expense. If this is an example of new vehicle manufacturing to have to replace safety components every 2 years. I would rather go back to the older vehicles. There are no grease fittings on the new stile ball joints.

- Binghamton, NY, USA

problem #122

Oct 022004

Dakota 4WD 8-cyl

  • Manual transmission
  • 67,571 miles
I took my 1999 Dodge Dakota pickup truck in to have it aligned. The mechanics at big O tire told me it could not be aligned due to bad upper and lower ball joints and tie rod ends. Big O tires informed me that not only were the parts worn prematurely, but that it presented a dangerous situation and that my wheels could fall off the truck. I did not believe big O, so I took the truck to loveland bear alignment for a second opinion. Loveland bear alignment verified what big O told me, and in addition told me that to use Chrysler parts would not be acceptable because the Chrysler replacement parts were as defective as the parts being replaced and that it would not solve the problem of premature wear and danger of the wheels falling off. The vehicle had 67,571 miles on it at the time I was told this. Due to both the safety concern over my wheels possibly falling off and the need to align the vehicle to avoid wearing out my new tires, I ordered the ball joint and tie rod ends replaced with lifetime warranty aftermarket parts followed by alignment. The repairs to my vehicle cost approximately $1,037. So far, the only consequences were premature wear on the last set of tires and the fact that I was compelled to replace the parts for safety concern and the ability to perform a front end alignment on the vehicle. The old parts are not available. I now understand that there is a recall in effect for this vehicle but only for 2000 and newer vehicles. I want you to be informed that the defect also affects at least some vehicles manufactured in 1999 and to request that you extend the recall to include my vehicle.

- Longmont, CO, USA

problem #121

Oct 202004

Dakota

  • Automatic transmission
  • 86,000 miles

A D V E R T I S E M E N T S

Ball joints were repaired three times. Consumer stated the ball joint was too close to the engine, and caused them to rupture. Problem continued to happen.

- Panacea, FL, USA

problem #120

May 222002

Dakota 4WD 6-cyl

  • Automatic transmission
  • 28,000 miles
Both upper and lower ball joints was ng when I went for inspection. I couldn't believe I was driving this vehicle like this. I now think they are getting bad again....

- Rehoboth, MA, USA

problem #119

Nov 282001

Dakota 4WD 8-cyl

  • Automatic transmission
  • 49,000 miles
Replaced ball joints twice in my 99 Dakota 1 time with Dodge part should I have to pay for them again come on have them call the early one back to or should I not replace them and sell the truck to some person with out the knowledge I know it's a hard but please stick up for the little guy or girl the Dodge boys new about this for years but I think they but hope it just wash away please help us.

- Sharon, WI, USA

problem #118

Jan 012001

Dakota 4WD 8-cyl

  • Automatic transmission
  • 60,000 miles

A D V E R T I S E M E N T S

Why is the 1999 Dodge Dakota not included in the ball joint recall. My 1999 Dodge Dakota had a bad upper ball joint at less than 60,000.

- Goose Creek, SC, USA

problem #117

Jan 012004

Dakota 8-cyl

  • Automatic transmission
  • miles
Bad ball joints! 1999 Dakota R/T.

- Springfield, MO, USA

problem #116

Dec 112003

Dakota 6-cyl

  • Manual transmission
  • 60,000 miles
Upper ball joints are very loose and could separate from control arm. I believe the ball joint recall should include my 1999 2 wheel drive Dodge Dakota because it also is in great danger of the front suspension collapsing whle driving.

- Port Monmouth, NJ, USA

problem #115

Dec 012004

Dakota 8-cyl

  • Automatic transmission
  • 47,000 miles
Not necessarily an incident, yet... but how come 1999 Dodge Dakotas are not affected by the new recall on the ball joints"!!?!? the '99 is the exact same design as the 2000 Dakota. I have a rwd 99 Dakota, and I had the ball joints replaced 3 times since I've owned it. Three times. Daimler Chrysler doesn't care if our wheels fall off?!? I had warning once of three times when my ball joints were shot. What were to happen if I rolled my truck and died"! I can't believe that the recall for the ball joints only affects the 2000-2003 models, I know from plenty of other Dakota owners, the 99's are every bit as bad, if not worse. Same design = same problems. I'm not paying for DC to do my ball joints again, there is no reason the 1999S should be excludeed from the recall. If the balljoints on the 200S are bad, then being the same ones on the 99S will go just as bad. I'm glad to see somebody finally stepped in and did something about this, but I am very dissapointed in the fact that the recall doesn't include all the years with the same design flaw. There is no reason for it, and quite frankly, it infuriates me.....

- Las Vegas, NV, USA

problem #114

Dec 112004

Dakota 4WD 8-cyl

  • Automatic transmission
  • 83,000 miles

A D V E R T I S E M E N T S

I have a 1999 Dodge Dakota 4X4 with the same ball joint safety issue that has resulted in the recall of 2000 - 2004 models. Dodge is refusing to fix the safety related issue. I spoke with stew hansen Dodge (where I purchased the vehicle) and they will not fix the issue under the current recall.

- Waukee, IA, USA

problem #113

Jul 282004

Dakota 4WD 8-cyl

  • Automatic transmission
  • 84,156 miles
I had handling issues with my 1999 Dodge Dakota. Also, my front tires were wearing out on the inside. I thought I had a alignment problem and took my truck in for repairs. I was informed and shown that my ball joints (upper and lower) and tie rods were severely worn out and needed repair. Today, on the news, I heard about a recall for 2000-2003 Dakotas for this defect. Is there anything in the works to include 1999 Dakota's?

- Olympia, WA, USA

problem #112

Jul 182003

Dakota 4WD 6-cyl

  • Automatic transmission
  • 56,884 miles
The steering of my vehilcle displayed excess movement and made a clicking / loose kind of sound when changing steering direction. It was necessary for me to replace the front end of my 1999 Dodge Dakota. This consisted of the upper and lower ball joints on both sides. This was not covered by the dealer. I had all work performed by my local mechanic at my expense. I saw the article on line regarding the possible recall and would like to know if my vehicle as well as those of others who have experiencedn this condition and have paid for these repairs themselves can be considered part of this action and possibly receive reinbursment to off set these expenses.

- North Attleboro, MA, USA

problem #111

Oct 052004

Dakota 6-cyl

  • Automatic transmission
  • 5,000 miles
Ball joint failure right front side, and now the left front side is going out.I replaced the part myself with a greasable ball joint.

- Springfield, MO, USA

problem #110

Aug 012004

Dakota 4WD 8-cyl

  • Automatic transmission
  • 67,000 miles
The upper and lower ball joints had to be replaced at 60K miles. I had mechanics at ntb take a look at my truck, and they said that driving with the ball joints in such a condition was extremely hazardous.

- Raleigh, NC, USA

problem #109

Mar 172002

Dakota 4WD 8-cyl

  • Automatic transmission
  • 50,000 miles
Upper and lower ball joints, tierod ends on both sides went out on my 1999 Dodge dakoda. Had then repalced twice already and cost alot of money.

- Mauston, WI, USA

problem #108

Aug 152000

Dakota 8-cyl

  • Automatic transmission
  • 38,000 miles
Continuous ABS problems. Some times the ABS brakes will apply without touching the brake pedal, most of the time the ABS won't work at all, ABS sensors are continuously needing replacement, all 4 front end ball joints worn out, noisy rear end, only 50,000 miles.

- Roseland, LA, USA

problem #107

Nov 222004

Dakota 6-cyl

  • Automatic transmission
  • 201,000 miles
1999 Dodge Dakota-upper and lower ball joints. Notice a clanking noise during rough roads and in turns. In icy conditions, the control of the vehicle can be poor. Prolonged wear can cause the entire wheel to fall off at any speeds. I have been on many other forums to see if any one else has had to replace these. It seems to be a very frequent thing for people to have to replace these. Upon removal of the ball joints, I discovered that they were missing one thing that keeps them from wearing out....grease. New upper and lower ball joints are to be replaced asap before a serious accident occurs.

- Eau Claire, WI, USA

problem #106

Nov 182004

Dakota 6-cyl

  • Automatic transmission
  • miles
1999 Dodge Dakota ball joint.

- Honolulu, HI, USA

problem #105

Aug 012004

Dakota 4WD 8-cyl

  • Automatic transmission
  • 30,000 miles
(1) normal on-road use (2) premature ball joint wear and failure causing suspension noise, looseness and dangerous driving conditions (3) ball joints replaced with quality aftermarket supplier parts (moog)

- Uniontown, OH, USA

Read the next 20 complaints »

Not what you are looking for?