- December 20: No Recall of 50 Million ARC Airbag Inflators, For Now news | 3 days ago
- November 12: Chrysler 300 and Dodge Charger Door Panels Warp: Lawsuit news | 41 days ago
- November 8: Chrysler Pacifica Hybrid Class Action Lawsuit is Paused news | 45 days ago
- November 7: Dodge Hornet Hybrid and Alfa Romeo Tonale Hybrid Recalled recalls | 46 days ago
- October 8: Enel X Way Closure and JuiceBox Charger Fires Investigated investigations | 76 days ago
Transmission Whining
2010 Chrysler Town & Country
This problem may be covered under warranty. Ask your Chrysler dealer.
8.3
pretty bad- Typical Repair Cost:
- $2,900
- Average Mileage:
- 97,100 miles
- Total Complaints:
- 6 complaints
Most Common Solutions:
- replace transmission (3 reports)
- not sure (2 reports)
- being told bearing between 2nd and 3rd gear (1 reports)
transmission problem
Helpful websites
- No one has added a helpful site for this 2010 Town & Country problem yet. Be the first!
A D V E R T I S E M E N T S
This van was bought used with 43,000 miles on it. After getting around 50,000 miles I noticed a whine in the Transmission that would change pitch as it shifted through the gears the worst in 3rd. This was a progressive noise that over the course of 18 months or so is getting louder and louder in the cabin. Bad enough that you could not talk hands free on a phone for it being to loud. I new this was going to be a bearing failure and that it was not going to heal itself and when it does break, the vehicle would come to a stop. Being a mechanic and ASE certified. I dropped the trans, pan looking for metal. With none found I decided to take it to a Transmission specialty shop. For I don't have a lift, nor some of the specialty tools, and I also have not tore down an automatic transmission in years. I have also learned that this shop installed some new updated parts into the valve body that improve function. Did I mention I don't have access to Dealer Manuals and TSB's as well. So the easiest this was to have them R&R mine.This they did. Saving the old parts for my inspection. The main failed part was a large tapered roller bearing at the back of the case for the main shaft. Gulling and Brinelling to the extent that I don't think this bearing would of lasted much longer. Also other bearings and needle bearings planetary gears are all discolored. Long story short, complete rebuild, no warranty. and the Trans. shop is not sure why this happened so early on. But they have seen it before and even on other makes.
- kc2ytj, Cheektowaga, US