CarComplaints.com Notes: Engine cradle rot is a serious problem in the 2004-05 Chrysler Pacifica. Chrysler admits they didn't apply enough coating to the vehicle's sub-frame during assembly, but only offered to cover a very small portion of the vehicles they messed up.

So what happens when your engine cradle rots? Well, the engine could fall out for starters. It could also cause problems with the suspension and other components but did I mention THE ENGINE CAN FALL OUT? The worst part is you might not know because there's no way to see the problem without getting under the car.

If you have a 2004-05 Pacifica, make sure to have your mechanic inspect your sub-frame for rust and corrosion.

2.3

hardly worth mentioning
Crashes / Fires:
0 / 0
Injuries / Deaths:
0 / 0
Average Mileage:
67,900 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

2004 Chrysler Pacifica suspension problems

suspension problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2004 Chrysler Pacifica:

Unsubscribe any time. We don't sell/share your email.

2004 Chrysler Pacifica Owner Comments

problem #1

Mar 042006

Pacifica 4WD 6-cyl

  • Automatic transmission
  • 67,900 miles

A D V E R T I S E M E N T S

: the contact stated the rear control arm fractured. It was driven on the faulty control arm to an independent repair shop. The vehicle was inspected by the mechanic and repaired. It was taken for state inspection and failed due the inner tie rods needing replaced. The vehicle was taken to the dealer for inspection or repairs.

- East Stroudsburg, PA, USA

Search CarComplaints.com for these popular complaint phrases...

Not what you are looking for?