CarComplaints.com Notes: The 2015 Chrysler 200 carries the torch of "never buy the 1st year of a new vehicle generation" with pride.

The 2015 model year is the first year of the Chrysler 200's 2nd generation. It has been plagued by problems from the start. Transmission failure at extremely low mileage, many recalls, problems stalling while driving... the list goes on. Maybe Chrysler should have stuck with the 1st generation.

10.0

really awful
Crashes / Fires:
14 / 1
Injuries / Deaths:
7 / 0
Average Mileage:
28,210 miles

About These NHTSA Complaints:

This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.

So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.

2015 Chrysler 200 body / paint problems

body / paint problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2015 Chrysler 200:

Unsubscribe any time. We don't sell/share your email.

2015 Chrysler 200 Owner Comments (Page 2 of 2)

« Read the previous 20 complaints

problem #5

Jun 162015

200

  • 8,000 miles

A D V E R T I S E M E N T S

1.delayed/harsh shift from 2nd to 3rd gear. Especially harsh when the vehicle was cold. 2.vehicle lunges forward when downshifting rapidly. For example, if I was driving 55mph and had to stop quickly, as the transmission downshifted the entire vehicle would thrust/jump around 3rd-4th gears. It almost feels like the car is going to accelerate instead of stopping. 3.in a situation where the vehicle is slowed, but not stopped, and then accelerated (such as exiting a parking lot onto a major road), once the accelerator is applied, the engine rpms shoot up, but the transmission delays dramatically before upshifting, causing the vehicle to jerk. 4.at speeds between 24-26mph, the transmission jumps around wildly between gears causing the vehicle to jerk. After multiple service visits and software updates, the transmission and torque converter were replaced. The vehicle has been driven for over 3 weeks since this repair, and issues 2, 3 & 4 still exist. Other issues: 1.intermittent extended crank time'2-3 times longer than a typical crank before starting. A.engine code showed the dealership there had been extended crank times. Dealership attempted repairs, citing an oil pressure problem, but issue continued. B.on a separate service visit, we were told this was due to a recall and they were awaiting parts. C.recall work was performed around 12/1/15, but the issue still exists. The issue has actually gotten substantially worse since the weather has gotten cold. 5.'park' not engaging properly. When putting the vehicle into 'park', there was a loud clunking sound. When the brake was released, the car would roll forward. A.this issue seems to have been resolved by repairs around 12/1/15.

- New Bern, NC, USA

problem #4

Aug 222015

200

  • 10,711 miles
Noticed that my front bumper is warping away from the headlights and is also damaging the body paint as a result of flexing when driving. This is now the 4th issue with this vehicle since purchase to go along with my multiple repairs for brakes, transmission, and esim (fuel system).

- N Las Vegas, NV, USA

problem #3

Jun 232015

200

  • 30,000 miles
Sheet metal welding issues that causes water to leak into the backseat and cause major carpet damage.

- Redford, MI, USA

problem #2

Apr 102015

200 6-cyl

  • 11,000 miles
I read the manual from first page to last when I purchased the vehicle 1) no mention of sliding arm rest and the fact that it doesn't lock in position. Very stiff to move from driver position, so I wasn't aware 2) when arm rest is slid forward it encroaches over the rear cup holder. 3) when cup holder/console storage cover is slid back halfway and locked in position, the armrest when slid forward encroaches over both cup holders. Appears very hazardous, so unbeknownst of this feature and while I was accelerating from 0 mph at traffic light that had just changed to green, the passenger in the back seat had pushed on the arm rest for an unknown reason (probably thinking it was stationary). As the arm rest shot forward, it squashed and propelled my large coffee cup through the cockpit area. Luckily it was not hot, but the problem was that it was a complete distraction not knowing this could happen. When I looked to see what the heck was happening, the vehicle in front of me had already been braking to stop. For that split second I wasn't paying attention to my driving from the distraction, I crashed into the rear of the vehicle in front of me. A design flaw? maybe add a locking mechanism. This is very hazardous without knowing the sliding armrest feature that could sever a drink cup in half while driving. I'm calling Chrysler customer service (800) 247-9753 and Chrysler group recall assistance (800) 853-1403 I know I'm responsible for the control of my vehicle, but something needs to be done about this hazard and I may seek compensation for my deductible. Yeah, good luck with that, right?

- Grand Ledge , MI, USA

problem #1

Dec 062014

200

  • 500 miles
As I pulled out onto the highway, my car began to stall, it would not pull forward. It made a noise like the transmission is going out. So, I came to a complete stop and started on my route again. This has happened several times. The last time was 2/21/2015 at just over 5100 miles. My car would not change gears, so I had to come to a complete stop and turn the car off and restart the car in order for the gears to change. I have also noticed that the floor board on the drive side passenger floor is wet. I have no idea where the water is coming from.

- College Park, GA, USA

Not what you are looking for?