CarComplaints.com Notes: Since the Chrysler 200 first hit the streets, owners across the U.S. have complained about how their “dream car” quickly turned into a complete nightmare because of how the engine dies suddenly while driving.
10.0
really awful
Crashes / Fires:
2 / 1
Injuries / Deaths:
0 / 0
Average Mileage:
49,438 miles
About These NHTSA Complaints:
This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.
So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.
The contact owns a 2011 Chrysler 200. The contact was driving approximately 10 mph when the check engine and ABS indicators illuminated on the instrument panel. Additionally, the vehicle stalled. The failure recurred for three years. The dealer replaced two sensors, but the failure recurred. The manufacturer was notified. The approximate failure mileage was 108,000.
After a shifting update performed at Chrysler dealer in Jan 2014. The car S transmission runs odd. The RPM sticks at 3 while driving 35 mph. The RPM gauge June while driving even w cruise set. Slow and hesitant while up hill or speeding up. Took to dealer 3xs w same issue no results. No warning lights or codes. One day the warning light dinged a few times while driving car but still no lights/codes. Dewey said drive it til it stalls (it has) or til dash light comes on.
Car is a Chrysler 200, 2011, I was making a right turn, and the car stalled, the speed was around 10 mph, I contacted the Chrysler dealer near my home and they told me that " do not know why the vehicle stalled " I explained, I was driving make a right turn and car stalled, and nothing works, car die, told me to bring the vehicle and I will be charge for it. I when to this site and I found out that is a known issue with this car, why the dealer told me that " and why the NHTSA do nothing about, is very dangerous, I could be involve in an accident, could be injury or a fatal. NHTSA waiting to be fatality in order to get involved????? why we have to die " to take actions.please fix this terrible issue.
First incident I was leaving a parking lot my car stalled,2nd after a stop sign, 3rd pulling out of a driveway. And today at a stop light. Cannot get an appointment at dealership for 3 weeks since I need a loaner car. If it happens again, I will drive it there and demand it be fixed.
The problem: Popping #33 fuse (switch bank/diagnostic link connector/PCM), have been replacing fuses each and every time so I can go on with my business. I find that it happens between shifting gears. It does not matter if you are in drive/automatic mode or auto-stick mode. Did not turn my car in right away (now I wish I would have) because I would have felt silly if I had my car towed and the tech. Found that a $.25 fuse was blown. This is a very serious issue with a risk factor through the roof because the drive train completely shuts down. No power steering, no power brakes. At highway speeds you pucker up and hope you can make it to the side without getting into an accident before your car comes to a complete stop. First time it happened, it just rained heavily and I thought something got wet - entering the freeway up shift from 2nd-3rd 34084 miles second time, turning into my driveway downshift from 2nd to 1st - coincidence? 35028 miles third time, abrupt stop downshift from 6th to 1st 36013 fourth time - pulling into work downshift from 3rd to 2nd 37112 fifth time - slowing down on expressway downshift 5th to 4th 38223 sixth time - slowing to a stop downshift 2nd to 3rd 38,764 seventh time - during rush hour stop and go traffic (the last straw) up-shift 2nd to 3rd 39,134 eighth time - within 15 minutes of seventh time stopping at a stop light. Downshift 2nd to 1st 39,146 ninth time - next morning on my way to the dealership - up-shift from 4th to 5th 39,164 went to dealership and made an appointment. Luckily I am conscious of my surroundings and was able to get out of harms way every time. I will not let my wife drive this car, for her safety, until it is fixed. Is there a documented fix for this?
- Farmington Hills, MI, USA
Search CarComplaints.com for these popular complaint phrases...
When I was making a gradual right hand turn (curve to the right) at approximately 15 mph, on flat land, I experienced total engine shutdown, electrical shutdown, and loss of power steering in a split second - without warning. After I gathered my composure, I put the car in park, turned the ignition off, then turned the ignition back on and I was on my way without issue since. My 2011 Chrysler 200 (4 cylinder) has only experienced this 1 time, but once is definitely enough for me!
While setting the cruise control on this rental vehicle (enterprise car rental), my knee accidentally bumped the ignition which ended up turning the car off. Realizing that the car was slowing down, I assumed that the cruise control setting hadn't taken. I tried to give the car gas manually and couldn't get the car to speed up. Unable to maintain speed, I attempted to maneuver the car to the shoulder amongst trucks and cars going 65 mph + on the 3 lane interstate highway. The hazards and turn signals were inoperable and the steering locked up. I narrowly escaped collision. I was able to restart the car on the shoulder and continue traveling.
2011 Chrysler 200. Consumer writes in regards to vehicle engine cutting off while driving. The consumer stated the dealer was unable to find a problem.
Car stalled on the throbs neck expressway while sitting in heavy traffic. When I got the car started again it initially wouldn't move. When I did make off the highway the car shut off on me completely. I barely made ut back to New Jersey in the car because the car struggled to accelerate & move all the way home.check engine light is on as well as several other lights on the dash board. I had my entire family in the car that night (2 kids; husband & mother in law). I have been to the dealership 5 times to this issue & its not bern solved yet. This is my second complaint about this car to the NHTSA this time is more urgent because this car stalled in heavy traffic on a major highway this could've ended so badly.
I purchased a 2011 Chrysler 200 in July of 2011. I have had multiple incidents where my vehicle has stalled with my foot on the brake sitting at a stop light. I have taken in the vehicle to be serviced 4 times in 1 year for this reason. And I have been told each time it is something different causing the problem. Also I have had two incidents where my vehicle would not start. I have had to have it towed twice in one month to the dealership, and both times I have been told it was my fuel pump. And there is one other time I took my vehicle in because it would have a slow crank and this incident I was told it was my battery so they replaced that. Also just to mention my vehicle is currently only has 17,280 miles on it.
The contact owns a 2011 Chrysler 200. The contact stated that while driving 15 mph, the vehicle stalled without warning. The contact restarted the vehicle and the vehicle functioned properly. The vehicle was taken to the dealer for inspection however, the cause of the failure was unknown. The vehicle was not repaired. The manufacturer was not notified. The failure mileage was 16,000. The VIN was unavailable.
The Chrysler 200 engine will stall when coming to a stop or already stopped. The engine fades slowly away and then completely turns itself off. This entire engine failing process lasts for approximately 7 seconds. This engine failure pose a significant safety risk and something needs to be done Chrysler dealership are aware of this issue, but unfortunately don't have an answer for a resolution of it. This issue needs to be looked at much closer and in-depth, since further delays could cause accidents and death. I plead that Chrysler takes responsibility for this problem and commence a recall program of the Chrysler 200 model. I've personally experienced the engine failing 4 times already. I brought it into the Chrysler dealership and have them take a look at it. I had to let the car sit at their shop for 2 days and they did not offer/give a free rental car for me. This car is under 1 year old. Prior to Chrysler I only owned foreign cars because of the perceived notion that american made cars are not reliable. I decided to give it a chance and wanted to buy american, so I got the Chrysler 200. So far that decision has turned out to be a big mistake (unless Chrysler offers a resolution to this problem). I don't want to lose faith in the american car company and hope that they do the right thing.
I stopped at a red light, light went green and I let off the brake and car doesn't move. I pushed the gas and it still doesn't move. Also the engine makes no noise.. car was still on so I had to put in park and turn car off and restart to get it going. Very dangerous and this is the third time its happened.
The contact owns a 2011 Chrysler 200. The contact stated that while traveling between 20-30 mph, the vehicle decelerated independently. The vehicle was not taken to the dealer. The manufacturer was not contacted. The vehicle was not repaired. The failure and current mileages were 19,900.
While sitting at a red light during my drive to work, the engine of my Chrysler 200 simply shut off, with no warning light or indication associated with it. The car turned on without trouble when attempting to restart it. This is the second incident involving a stall with this vehicle. The first was August 29th, 2012, also at a red light during the drive to work.
This is the 2nd time this has happened in 11 months. (not sure of the exact date prior to most recent) was slowing to a stop, and once stopped, the car stalled. Both times it happened the check engine light "was not" illuminated. Everything on the dash appeared to work normally. Lights on, radio on, etc. I happened to feel the car rolling backwards, while stopped, and both times stood on the brakes to prevent the car from rolling back and striking the vehicle stopped behind me. (first time I actually thought I hit the car, but checked and did not see any damage) car restarted ok each time, and proceeded normally. In both instances, I was slowing to a stop (once from coming off the highway and stopping at a traffic light at the top of the exit ramp, and another time slowing to a stop from about 45 mph, on a city street) haven't notified the dealership (yet!) but became aware of this issue when I researched this on the internet. Add 1 more Chrysler 200 to the "stalling" issue! (Canadian vehicle - Ontario).
My new car stalled only a few days after I purchased it. I was at a stop light and I didn't know why I wasn't able to drive. I had to re-start my vehicle. Since then it has stalled about 12 times in the last year; always when I'm at a stop light. One time I was in the middle of an intersection waiting to turn left and it stalled on me. The dealer installed a co-Pilot after I escalated it and they were not able to diagnose it. The dealer called me on May 31, 2012 and told them that they would replace my car with a 2012 Chrysler 200 convertible since it was unsafe for me to drive. He mentioned that the first few convertibles that were built in the early months seemed to have this problem. I received my new 2012 convertible on July 21 but I am still fighting with them to get my service and warranty contracts.
I drove my car for approximately 25 minutes, I stopped at stop light and when pressed the accelerator the car would not go. I put the car in park, then back in drive and the still will not go, then I put the car back in park, turn the car off and then put the gear in drive and then the car would go. This has happened 3 times...I took it to the dealership and they told me they could not find the problem.
A D V E R T I S E M E N T S
- Silvania , AL, USA