This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.
So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.
Rear brake line appeared rusty and scaly, then when hit my brakes, the pedal went to the floor. I used emergency brake. I replaced rear brake line. All other lines appeared rusty and scaly. Now, my front left brake line is beginning to weep; it's moist and it glistens with oil. I will have to replace it soon. All the other lines in the truck appear to be the same, rusty and scaly. I will no doubt have to continue to replace each line.
The contact owns a 2005 Chevrolet Silverado. The contact stated that the vehicle failed to start accompanied by the illumination of the check engine warning light. The failure was recurring and sporadic. Additionally, the instrument panel failed and the head lights would sporadically fail. The contact also stated that the rotors needed to be replaced on a regular basis. The vehicle was taken to an authorized dealer, who was not able to diagnose the multiple failures. The manufacturer was notified of the failure. The approximate failure mileage was 1000.
I was driving down aa alley came to the street and had to hit the brakes hard, the line leading from the ABS block to the front left wheel ruptured. Complete loss of braking, ended up stopping the vehicle using the E-brake.
Brake lines rusted out. Truck failed to stop within a safe distance on the highway. Brake line gave out on the highway no warning at all. Just a soft, non functioning pedal. Luckily I was able to pull the truck over to the side of the road no accident.
- Port Saint Lucie, FL, USA
Search CarComplaints.com for these popular complaint phrases...
The contact owns a 2005 Chevrolet Silverado. The contact stated that the air bag sensor light was illuminated. The vehicle was diagnosed by an independent mechanic that determined a sensor inside the front bumper was the cause of the defect. The contact also reported that the driver's side rear brake line was rusted and ruptured, which caused the rear brakes to become inoperable. The vehicle was not diagnosed or repaired for the problem. The manufacturer was not notified. The failure mileage was 72,000.
The contact owns a 2005 Chevrolet Silverado. The contact stated that while driving approximately 20 mph and depressing the brakes, the brake pedal abnormally traveled to the floorboard. The contact applied the emergency brake. The contact crashed and rear ended another vehicle. A police report was filed. There were no injuries reported. The vehicle was towed to a dealer where it was diagnosed that the brake lines were corroded and needed to be replaced. The contact stated that he was advised that the parts were on a national back order. The manufacturer was not notified of the failure. The vehicle was not repaired. The approximate failure and current mileage was 102,000.
The contact owns a 2005 Chevrolet Silverado. The contact stated that while driving 25 mph and depressing the brakes, the pedal abnormally traveled to the floorboard. The contact inspected the vehicle and noticed that the brake lines were corroded. The vehicle was not repaired. The manufacturer was not notified. The failure mileage was 95,000.
Approaching a 4 way traffic signaled intersection when signal started to change to yellow. Decided to not proceed through intersection so applied brake pedal to stop. Pedal went directly to floor, brake dashboard light illuminated. Vehicle would not stop and proceeded through intersection, while vehicles to my right proceeded to move. I had no brakes at all. I maneuvered vehicle onto a parallel access road and vehicle eventually rolled to a stop. Upon inspection it was obvious that there was a failure of the braking system, as hydraulic fluid was on the road in the vicinity of the right front of the vehicle...only... I was always aware that I had some braking capacity when I had a brake failure. Following 8 days at a GM dealership and a bill for $2,000, the brake lines were replaced following the diagnosis "rusted/corroded brake lines". a complaint to GM has fallen on deaf ears.
I was driving my truck into my driveway when I put my foot on brake pedal it went to floor, no warning. When I looked under vehicle brake line was leaking, very rusted.
Rear steel brake line corroded and blew out causing brake failure. This has happened to four people I know. One of those people had a bad accident. All vehicles were Chevy Silverado.
On our 2005 Chevy Silverado 2500 hd the ABS system has been kicking in when coming to a stop and you almost hit the car in front of you. I have read a lot of issues with this and I have not seen a recall for this year of the Chevy truck. The recall only stops at 2002 trucks. How many people have to be injured or killed before you guys decide to recall this year of the Chevy truck"??"
The first incident occurred in August 2013. When backing up (at approximately 5 mph), I stepped on the brakes and the brakes failed. The brake line was replaced over the right side of the rear end housing. On October 3, 2013, another brake line failed causing the brake pedal to go to the floor of the truck. This time the brake line is on the left side of the frame under the driver's compartment.
The brakes went out backing in to a driveway and all the fluid leaked on to the driveway and street. This could of been very serious if it happened on the highway coming home from picking up furniture. All the brake lines were rusted and had to be replaced"????? costly for us"
I went to slow to make turn and brakes went to the floor suddenly so I used emergency brake to stop. I believe all lines will need to be replaced as other look as rusty. Rust has been an issue for last 2 years with rotors needing replace then bearings in front rusted and anti-lock brake light would come on and pedal would surge. This is the worse Chevy truck I ever bought as even seeing rust already in lower panels and entire frame. Looks bad for only 53,474 miles.
Driving back to work from lunch on busy 4 lane highway, brake pedal went to floor. Narrowly avoided a collision at a red light. Put flashers on, lowered the gear selector, and used combo of minimal brake pedal and E brake to make it back to the parking lot at work. Upon inspection, large puddle of brake fluid on driver side near gas tank. Large leak in highly corroded brake line. All brake lines in similar condition and are currently being replaced in the shop. Transmission lines and fuel line are in similar highly corroded condition.
I had a soft brake pedal on my 2005 Silverado. I thought I had a bad master cylinder. I work at an Audi dealership and I was bringing the vehicle to work to check it out. As I approached the driveway to work, the brake pedal went to the floor. I used the emergency brake to slow down and pull into, the driveway. We inspected the vehicle at work and found that a steel brake line under the drivers side that runs along the frame rail had a hole in it due to rust. I find this completely unacceptable that a steel brake line rust through. Chevrolet used a poor material on their brake lines. I have been in the automotive business for 31 years in Connecticut ( yes, salt is used on the roads ) and have worked for Ford, Volvo, Hummer and Audi. I have never seen a brake line rust through. Chevrolet needs to fix this issue at their expense and not the consumers. The dealership wants $1500 to repair using the same brake lines. I have purchased stainless steel lines and will perform the repairs at my shop.
Brake line burst due to corrosion causing loss of rear brakes. I have since had three more brake lines (completely different lines) start to leak due to corrosion causing loss of rear brakes again and then front brakes. The brake lines are severely corroded which is unusual on a vehicle with low mileage and less than 10 years old.
The contact owns a 2005 Chevrolet Silverado. The contact stated that while driving approximately 25 mph, he depressed the brake pedal but the brakes were hesitant to respond. The contact inspected the vehicle and noticed corrosion and brake fluid leaking from the brake lines. The manufacturer was not made aware of the failure. The vehicle was not repaired. The approximate failure mileage was 130,000.
A D V E R T I S E M E N T S
- Harrison, MI, USA