This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.
So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.
The ABS have failed again. They were recalled in 2005 - 06 and the "fix" of cleaning them was obviously not the correct way of handling the problem. There has been no incidents as of now but there will be.
Front ABS sensors on GMC 350 trucks. They are bad just like the 250 & 150 P/U trucks. We had too have ours fixed due to a near miss accident caused by not working properly under 10 mph shoud be a recall.
2001 Chevrolet Silverado 5.3L 4+4 anti-lock brake problem, same as in Canada. Truck won't stop at low speeds. Anti-lock brakes kick in and truck continues moving. Many near miss accidents, including almost running into gas station, concrete curb stop only thing that stopped me. All in one trip to gas station. Haven't driven truck since. Truck only has 34,500 miles on it. Very dangerous condition! needs fixed. Your more than welcome to see for yourself.
On my 2001 Chevy Silverado my antilock brakes activated as I was coming to a stop causing me to run into the back of a parked pick up truck with its tailgate down luckily only damage was smashed turn signal and headlight/turn signal bracket
The wheel speed sensors, rust build up between the sensor, and the mount of the sensor. At low speeds the wheel speed sensor malfunctioned while driving at 10 mph, which caused the ABS to disengage, causing the system to pulsate.
While driving at 25 mph consumer noticed the ABS motor was continuously running, and the brake pedal was getting hard while applying the brakes. This caused extended stopping distance. Mechanic drove the vehicle to the repair shop. Also informed mechanic determined that the ABS control module, and both front wheel hubs needed to replaced. Dealer was notified. The consumer stated that the left front wheel hub assembly needed to be replaced. The consumer stated that he almost had 2 accidents because ABS brakes failed and will not stop the vehicle. Front wheel hub assembly was replaced by K R auto repair. New ABS control unit installed.
Anti-lock brakes activating while traveling at low speeds. While attempting to get gas the vehicle would not stop. As a result the consumer struck another vehicle parked at the pump refueling.
Consumer complained that two more front speed sensors had to be replaced after reporting this issue to hot line back in February, 2004 about a brake problem. Dealer was notified.
When stopping and the vehicle's speed reaches 5 mph, the ABS engages. When this occurs controlling the vehicle is difficult, when going straight and the vehicle is uncontrollable when turning. The dealership feels that the ABS sensor which controls the ABS at 5 mph may be corroded and needs to be cleaned. The ABS sensor has been cleaned and the problem ceased. The consume was told that this is a cold climate problem. There are technical service bulletins issued but there are no recalls at this time.
The ABS sensor failure resulted in service brakes failing to stop the vehicle immediately. The consumer had to depress the brake pedal several times to stop the vehicle. The brake pedal was hard when this occurred. The problem was also present while being repaired.
A D V E R T I S E M E N T S
- Dryden, NY, USA