This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.
So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.
The contact owns a 2000 Chevrolet Silverado. While driving at a very low speed the contact applied the brakes and the anti lock brake system engaged. During the failure the vehicle also experienced an increased in stopping distance. The manufacturer was notified and the contact was told that the vehicle was not included in NHTSA recall campaign number 05V379000 (service brakes, hydraulic:antilock). Updated 05/04/11 updated 05/13/11
The contact owns a 2000 Chevrolet Silverado. The contact stated that when applying the brakes from 10 mph or less, the brakes would abnormally lock. The dealer recommended replacing the sensors at the contact's expense. The contact stated that the vehicle was previously repaired under an unknown recall where the dealer cleaned the brake sensors. The contact was under the impression that the brake sensors should have been replaced under the recall. The failure mileage was 30,000 and the current mileage was 64,000. Updated 12/01/10 updated 12/07/10
The contact owns a 2000 Chevrolet Silverado. He stated that while driving at low speeds of 10 mph, the ABS engaged without warrant. When the failure would occur, it would cause increased stopping distance when braking at low speeds. The contact previously received notification of NHTSA recall campaign id number 05V379000 (service brakes, hydraulic: Antilock) and the dealer removed and thoroughly cleaned the wheel speed sensor, mounting surface on the bearing, applied rust inhibitor to the cleaned surface, greased the mounting surface, reinstalled the wheel speed sensor, and checked the peak-to-peak output voltage to ensure the wheel speed signal was within specifications. The failure recurred and the dealer advised they would not be liable for repairs due to previous recall repairs. The failure and current mileages were 99,000.
The contact owns a 2000 Chevrolet K3500. While driving approximately 30 mph, the ABS activated and caused the vehicle to continue moving when the brake pedal was depressed. The manufacturer stated that his VIN was not included in NHTSA campaign id number 05V379000 (service brakes, hydraulic: Anti lock). The vehicle has not been repaired. The failure and current mileages were 58,000. Updated 03/12/09. Updated 03/13/09.
- Hilton , NY, USA
Search CarComplaints.com for these popular complaint phrases...
Type : vehicle year : 2000 make : Chevrolet model : Silverado make : GMC; model : Silverado; I had a car accident and I think my anti-lock brakes locked up and thus I was in a extremely bad. My truck ended up rolling over 3 times down a hill before stopping. I want to know if the brake issue I was reading about under your investigation with the anti-lock brakes.
The contact owns a 2000 Chevrolet Silverado. The vehicle was repaired according to NHTSA campaign id number 05V379000 (service brakes, hydraulic:antilock); however, the contact is currently experiencing the failures noted in the recall. The vehicle has not been diagnosed by the dealer. The current and failure mileages were 98,000. Updated 11/17/08 updated 11/18/08.
The contact owns a 2000 Chevrolet Silverado. The contact received a recall notice in February of 2006 regarding the ABS. He took the vehicle in for repair on February 20,2006 at 105,284 miles. There were no failures at the time, but the repair was still made. The contact is now beginning to experience ABS failure one year later. Whenever he pulls to a stop sign and there is a rough spot or a bump in the road, the ABS fails. The brakes do not work as well. The vehicle has not yet been taken to the dealer. The recall number was unavailable. The failure mileage was 123,000 and current mileage was 126,000. Received 12/12/07. Eq-10208924-4200 recall# 00V055000 updated 12/12/07.
I recently bought a 2000 Chevrolet Silverado Z71 extended cab. A few days after I purchased the truck I was in traffic at speeds ranging between 2-10 mph. Almost everytime I pressed the brakes to come to a stop the ABS system would kick in and my truck would not stop for a few extra feet almost causing me to rear end the vehicle in front of me. Now I contacted Chevy/GM and they said there is a recall for the problem but unfortunately my truck under the VIN # I gave them did not qualify for the recall. They said I'm sorry but you'll have to get it fixed on your own. I was shocked at the response they gave me. I cant afford the close to $1000 repair and I still have to use the truck for work, but I know I won't buy another GM and I guess by the time the recall gets extended to my truck someone will either get hurt or killed do to GM not stepping up and taking no responsibility. Ever since then it happens often enough where im scared.
The contact owns a 2000 Chevrolet Silverado. While driving 30 mph he depressed the brakes and crashed into the vehicle in front of him. The air bags did not deploy. The front seat passenger sustained a lacerated spleen and contusion of the heart. A complaint was submitted to the manufacturer (complaint # 71-546827970). The current and failure mileages were 128,000. Updated 02-01-08 updated 02/01/08
The contact owns a 2000 Chevrolet Silverado. He stated that the ABS activated without warning which increased the stopping distance. There is a recall for the antilock brakes (NHTSA campaign #05V379000). The dealer repaired recall; however, the failure continued to occur. The failure and current mileages were 59,000. The consumer stated this is the 2nd repair, both times the speed sensors were replaced. The consumer provided a copy of repair invoice. Updated 08/29/07
The contact owns a 2000 Chevrolet Silverado. While driving approximately 55 mph under normal driving conditions, the ABS warning light illuminated and the antilock system stopped operating. The vehicle was taken to the dealer who stated that the pump motor circuit shorted. The vehicle has not been repaired and the light still illuminates. The antilock brakes fail to operate and the brakes function like normal brakes without ABS. The engine size was unavailable. The current and failure mileages were 88,791. Updated 06/14/07.
The ABS failed in my truck, causing me to hit a trailer parked in my driveway. While GM has already "repaired" this under a previous recall, their "repair" obviously doesn't work. They were unresponsive about my complaint, since my truck had already been "repaired". if someone would have been walking in front of my truck when the brakes failed, I would have killed them. It is one thing to have the radio quit working, it is an entirely different thing to have the brakes totally fail. GM needs to do something about this besides cleaning a couple sensors. There were no warning lights, no indication whatsoever of the impending failure. I backed up and the brakes worked fine. Still no warning lights. I spoke with the dealership and their answer was "there isn't anything we can test for this intermittent problem. We can try to get it to fail and go from there". I now have a 6000 lb projectile that I have no idea if it is going to stop or not. I removed the ABS fuse until I can figure out what to do with this unreliable product.
: the contact stated when the brake pedal was depressed, the pedal pulsated between 3-10 mph and the vehicle would not stop. A NHTSA recall, # 05V379000 was performed on the vehicle concerning, the service brakes, hydraulic: Antilock however, the recall did not remedy the problem. The dealership would not offer a second repair under the recall.
I own a 2000 Chevy Silverado 4X4. I have had a problem with the brakes for about two years. The anti-lock brake computer does not function properly all the time. I can loose the brakes at any time. I have talked to a few other owners of the same style truck and they have had similar problems. I have had the master cylinder replaced, new brakes installed, and the most recent recall to clean the brake cylinder(?) cleaned by a Chevy dealer completed. The problem still existed. It may have been 2-3 weeks in-between failures. What happens is the brake pedal goes to the floor with minimum stopping power. That's exactly what happened this last time but unfortunately this time I didn't have enough road to stop on and ran into a tree. Damages, according to the body shop, are going to be between $3000-$4000 dollars. The truck is in the repair shop at this time and I will have the anti-lock brake computer replaced. I know for a fact this is the cause of my accident. I was hoping for a recall from Chevrolet to avoid the expensive repair. I will save the old unit along with all the repair bills and future increases in my insurance premiums and hope that somewhere in the future the truck does get a recall. I will then in turn hold Chevrolet responsible for all bills incurred.
: the contact stated at speeds below 20 mph, the ABS activates, causing an excessive stopping distance. A NHTSA recall, #05V379000 was performed on the vehicle in September 2005 concerning, the ABS however, the recall did not remedy the problem. The dealership would not offer a second repair without charge under the recall.
: the contact stated while driving on wet road conditions at various speeds the ABS activates causing an increase in stopping distance. There is a NHTSA recall, # 05V379000, regarding the service brakes: Hydraulic: Antilock. The vehicle was not included in the recall due to the VIN. Updated 05/16/06.
: the contact stated the brakes where applied at 8-10pmh and the ABS engaged, resulting in the contact having a crash. To avoid a rear end collision, the contact left the road and hit an embankment on the passenger side of the vehicle. The police did not take a report at the scene and no injuries were sustained. After the accident the contact received a recall 05V379000, concerning the antilock brakes. The vehicle was taken to the dealer for inspection, the speed sensors were cleaned and it was determined the hydraulic pump needed to be replaced. However, the dealer was not able to determine whether the brake failure and accident were caused by the ABS sensor or the hydraulic pump. The contact felt the pump should have been included in the recall campaign. Additionally, the brake rotors were replaced, due to corrosion, after only 4,000 miles.
There was a recall on my Chevy truck for the ABS system. After the service my ABS system failed and the light remains on that it is not functioning. I called GM and they said that it was not part of the recall.. I have driven only 1700 miles since this service was done. I believe this problem should be taken care of by GM.
A D V E R T I S E M E N T S
- Morehead, KY, USA