This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.
So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.
Oem receiver hitch on my 2006 Chevy 2500 hd failed. The welds cracked and bent at a 15 deg angle. Towing a camper with the proper hitch well within the recommended weights. Chevrolet refused to examine or correct the problem because the vehicle was out of the initial warranty.
2005 Chevy pickup receiver hitch. After pulling a 6000 lb trailer several times my receiver hitch has worn thin and the drawbar slaps around in the 2" hole. The 5/8" hitch pin has worn the 5/8" hole elliptical.
Multiple failures of Chevrolet oem hitch receivers, I am employed as an aviation safety inspector for the houston Texas flight standards district office. My hitch is in the process of failing after towing a pop-up trailer less than 100 miles, it was used well within the limits of the hitch and my 2006 Silverado has approx. 600 miles on it. This failure is applicable to 1998-2006 Chevrolet SUV's and trucks. Please go to this link www.rv.net/forum/index.cfm and then search hitch failure. You will find over 200 posts about these failures. This defect has reportedly caused multiple fatalities and injuries when being used properly and GM will not acknowledge the deficiency. Please contact me by phone, I will send a picture of mine with the cracked weld. This problem can be rectified with a recall on these hitch receivers.
- Dickinson, TX, USA
Search CarComplaints.com for these popular complaint phrases...
A D V E R T I S E M E N T S
- Owings Mills, MD, USA