This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.
So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.
The contact owns a 2001 Chevrolet Silverado. The parking brake does not hold. Vehicle was taken to the dealership several times. Because warranty expired and dealership will not fix it. While under warranty one year after purchase they adjusted the parking brake and it started working again a couple of months later it happened again. They would constantly fix it while under warranty, and currently they will not do it. A recall was issued but this vehicle was not included in the recall due to VIN. The parking brake failed 6-7 times.
2001 Chevrolet Silverado developed parking brake failure. The parking brake failed causing damage components in the vehicle's rear axle. While doing research the consumer noticed that GM was recalling certain trucks with standard transmission but not including truck with automatic transmissions with the same problem.
2001 Chevrolet Silverado developed parking brake failure which caused damage to components in the rear axle assembly. The consumer did some research and found out that GM will be recalling certain trucks with standard transmissions with this problem but not automatic transmissions.
Right after purchase of the vehicle owner noticed there was no resistance in the parking brake. Owner noticed this after parking the vehicle in a parking lot. Then, the owner realized about a year ago that the vehicle can be operated with the parking brake engaged. There is recall 05042 for the same problem, but the recall is for manual transmission.
The contact stated thata recall was issued in April of 2005 for the parking brake, only including manual transmission. However, consumer's vehicle has automatic transmission, and he has had problems with parking brake. He states that the parking brake would not hold, it would just roll. From the time he purchased the vehicle there was no pressure on parking brake pedal, and this was unlike any vehicle park brake he had seen. Dealer told him that this was the way the new brakes were in vehicles. The parking brake was replaced, and worked well since then.
- Paradise, CA, USA
Search CarComplaints.com for these popular complaint phrases...
I have a 2001 Chevrolet Z71 truck, and the parking brakes will not pass the Texas safety inspection. The parking brake system should not fail during the lifetime of a vehicle, particularly since it has only 75000 miles.
The parking brake on my 2001 Chevrolet Silverado with an automatic transmission does not function or hold the truck from movement at all. Chevrolet dealership will not rememdy this problem without a significate repair charge. This vehicle has only 40,000 miles and no other brake issues. GM just recently issued a recall on this exact brake system but limited it to only vehicles. The text from a news publication on this recall reads: "the 1500 series of the Chevy Silverado between 1999-2002 and GMC Sierra pickups, the 2500 and 3500 series, between 2001-04, to repair the parking brake. The recall only affects trucks with manual transmissions, a total of 142,585 vehicles. Friction can lead to parking brake failures, which could allow unattended vehicles to move, GM said. " I have a serious concern with my parking brake, and it seems GM does as well, but limits it to manual transmission vehicles. Does this imply the parking brake on my automatic truck is not needed??
My 2001 chrevrolet Silverado truck has about 35,000 miles on it. I recently tried to actuate the emergency brake when parked. I discovered that the brake will not keep the vehicle from moving. It provides very little resistance when the engine is idleing and the transmission is in drive or reverse. I know of no damage done to the brakes that would cause this. This could result in the vehicle rolling downhill without a driver under certain circumstances. It could also result in injury to a person changing a tire or performing other maintenance which requires that the emergency brake be set.
The parking brake was defective. When parking the brake went all the way to the floor. When placing truck in gear with the parking brake on it will drive. Dealer stated that warranty expired. Dealer wanted to change the rotors and parts, but consumer would be charged for repairs. The consumer stated that the brake did not work from purchase. The consumer by another dealer that the brake was a poor design and would fail if driven 100 feet with the brake set.
Emergency brake on, vehicle gear in park, vehicle began to roll down hill. * bf council for consumer stated that injuries were sustained as a result of the failed brake. Consumer placed the vehicle in park and exited the vehicle leaving two minor children inside. The consumer noticed that the vehicle was rolling and attempted to catch the vehicle. The consumer fell and the vehicle rolled over her body. The consumer sustain severe bodily injuries. The vehicle struck a tree causing injuries and damages.
During a routine inspection, the consumer was informed that their emergency brake have failed the test. The dealership was notified, but did not resolve the problem. The cause was not determined.
While the vehicle was parked the emergency brake failed. This caused the vehicle to roll down the hill and ran over the driver. Driver sustained major injuries, and was transported to the hospital. The vehicle was towed to the dealer for inspection.
The rear rotors were pitting and needed to be replaced. This condition did not cause any problems while driving. The rotors should not have to be replaced so soon. Noise was heard in the rear. The rotors were composite rotors, layered metal instead of cast and were not to be turned or faced. The rotors were rusted out, the parking brake did not hold the vehicle on an incline (service bulletin# 10000172)
Parking brake will not hold vehicle on an incline and barely works when vehicle is level. With the parking brake on and the vehicle level the truck can be moved forward or reverse with the engine at idle speed when placed in gear. The parking brake is useless on even the slightest incline and the truck will roll freely in forward or reverse.
The parking brake fails to release the rear wheel when the handle is lifted. It has failed in the winters of 2001, 2002, 2003, 2004. The light on the dashboard goes out. One rear wheel is released. The other is not. The system fails repeatedly, making the driver hesitant to use the parking brake, for fear of not being able to resume movement.
I failed my state inspection due to the parking brake not holding. 3 different shops have told me this is a faulty design and needs to be replaced every two years regardless of use. This is not wear & tear, as I do not use my parking brake. This is a very expensive repair for something I don't use and should not wear out.
A D V E R T I S E M E N T S
- Covington, GA, USA