CarComplaints.com Notes: The 2016 Silverado has a few problems reported here & there, but that's to be expected for a popular model. More importantly, it has no significant problem trends -- both with our complaint data & same with complaints made to the NHTSA.
10.0
really awful
Crashes / Fires:
25 / 0
Injuries / Deaths:
4 / 1
Average Mileage:
37,621 miles
About These NHTSA Complaints:
This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.
So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.
I have found that when pressing my brake pedal, it gets very very hard and the truck doesn-??t want to stop unless I-??m practically standing on the brake pedal. My mechanic has been through the entire system and believes the issue stems from a faulty Vacuum pump. This is apparently a standing recall for my 2016 Silverado but when I supply my vin number it says that I have no unrepaired recalls. At no point has Chevrolet ever notified me that this recall needed to be completed. But my problem is exactly the same as the problems noted on the recall
When turning at low speeds the steering locks up, stabilitrack warning lights come on, entire dash and information center starts blinking then vehicle chutes down causing total loss of control.
Brake pedal hard to push down. Almost drove through shop door, going slow. Heavy equipment and cdl class A driver over 40 years. Fluid is full, brake pads and related items are correct. Shut engine off waited few minutes, seemed ok. It did it again immediately, hard two other drivers try with similar results. Odd noise coming from under hood when pedal is applied. No leaks observed or detected. Pedal is solid near top no fade at all.
The failing system is the hydraulic brake system. The brakes are failing in my vehicle causing it hard to stop, and having to press extremely hard on the brake for extended periods of time in order to properly stop. As I first push on the brakes I hear a squeak. Yes my vehicle is available for inspection any time. My safety as well as my four daughters safety has been at risk of a crash due to the hardness of trying to break or the vehicle not coming to a stop in time. Yes the problem has been confirmed by a local mechanic. There have no been any inspections in regards to manufacture, police officers, etc. My warning light and another light have previously came on and will later go off, it does not stay on continuously.
While driving my truck I was in line picking up my kids from school when pulling up close to the car infront of me my brakes got extremely hard and the truck kept slowly moving forward so I pressed harder to make sure I wouldn't accidentally hit the car. I just now saw a recall on the vacuum pump which in assuming is my issue with the harding of the brakes. I have not took it any where to be investigated yet
- New Summerfield , TX, USA
Search CarComplaints.com for these popular complaint phrases...
1. What component or system failed or malfunctioned, and is it available for inspection upon request" Response: Slowing down to make a left turn, Steering locked up, Electrical devices flashing, Service Stabilitrak Indicator, Chimming, Engine shut off then turned back on 2. How was your safety or the safety of others put at risk? Response: YES truck shut off when turning across traffic 3. Has the problem been reproduced or confirmed by a dealer or independent service center? Response: Has the problem been reproduced -Yes Response: confirmed by a dealer or independent service center -No 4. Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others? Response: No 5: Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear" Response: Yes, chimming, then Service Stabilitrak indicator, then steering wheel lock up, engine cut out
ok the problem is with the brakes, there were four incidents when the brake pedal gets hard and its hard to stop the truck. all four incidents happened backing into my driveway after stepping on the brake pedal 4 to 5 times it would hard. and it would be difficult to stop. The problem is with the brake booster vacuum pump. There was a recall for that exact problem on 2014-2018 silverados. I called the dealership, they told me my VIN # was not one of the listed ones for the recall. the vehicle is available for inspection if requested. the vehicle has not been inspected or confirmed by a dealer. there were no warnings lamps or messagesl. Im certain its the brake booster vacuun pump.
low RPM braking failure. Power assistance fails at low RPM (around 500 - 600) requiring me to apply full body weight to brake pedal to get vehicle to slow and stop. This is a well known and documented problem, but NHTSA won't extend a recall for this issue even when issuing recalls for same problem on other GM trucks, why?
The truck has had its major service to replace all fluids at 70,000 miles. One of the services was a notable vibration and shaking through the steering wheel and on the brakes. Higher the speed the more the vibration. When brakes are applied the vibration gets worse. The vehicles brakes and rotors were checked and good. The mechanic said that the brake pump was slightly loose and it was tightened. It did slightly ease the vibration, but less that a few days later it is back to the same vibrating. The brake power feels weak and when I need to brake I feel like the vehicle is not stopping. I have owner a 2014 Silverado before this and did not have this issue. I took it back to the dealer and they did an alignment which did not help.
My 2016 Chevy Silverado had intermittent hard braking. Especially at slower speeds the brake pedal would get very hard to press and needed a lot of effort to stop. I was especially concerned having newer drivers in my household that the truck was unsafe. I nearly hit others vehicles especially at stoplights and in parking lots. The vehicle was taken to the GM dealer who said it was under recall and completed the repairs. However even though the recall repairs were completed the vehicle still continued to have hard braking issues. It was not resolved until I had the brake vacuum booster pump replaced by a 3rd party as GM was unwilling to complete the repair under the recall
Backing up truck to put a boat in the water and no brakes had put push really hard to stop the truck from going in to the lake. When moving slowly there is hardly any brakes on the truck
Trailer brake system warning has been flashing non stop for 2 weeks. I do not use or tow anything with this vehicle. Usually it locks up the steering wheel while parking my truck and shuts down the engine. Yesterday I was going 55 on the highway and the warning came on and it shut down the truck tried to put the vehicle in park and rapidly applied the breaks then the truck electrical system came back too and the truck was rolling I pull off to the shoulder to shut the truck off and turn it back on. At the time I had both my sons in the vehicle 4 years old and 9 months. Again usually it always happens when parking my truck (under 5mph) it will lock the steering wheel and totally shut down the trucks engine. Huge safety concern.
Backing up slowly with/without a trailer and have to pump the brakes to stop or stand on the brakes or pumping the brakes and having to use the emergency brake to stop, rev up the engine, put in reverse and have to do the previous steps all over again. This only happens going slowly in reverse. I was told by a mechanic it could be the vacuum pump or TSB on the vacuum pump. No warning messages display. This is a safety risk to myself and others and could cause an accident.
Barking system. it seams like when I-??m in the city the brakes will not engage properly, at some point I-??ve had to use the emergency brake to stop. on the freeway the brakes work good but when running at low rpm it-??s like the brakes go to the floor and the truck is still moving. I went to get my brakes inspected and brake pads are still good, brake fluid was good. They told me to bring it in when the brakes fail again so they could see what was happening. Transmission was replace at 65000 miles because of a faulty torque converter
I was in a drive thru food chain going forward slowly. The brakes seemed hard and I had to really push hard to get the vehicle to stop. I went to a private mechanic who I trust totally. I had the front rotors and all pads replaced due to normal wear. We went on a trip with no braking issues. After returning home and backing down the driveway the brakes seemed hard again and was not stopping the vehicle properly. There were no warning lights on. This only seems to occur at very low speeds and is an alarming when it happens. I have been told by a dealership that there are no recalls on this vehicle. However looking on line I have seen videos and articles about faulty vacuum pumps and braking modules that needed reprogramming that effect braking as I have described. I don't want to take this to a dealership until I know for sure if there is a recall or not. Thanks
My 2016 Chevy Silverado is experiencing the same low speed braking problem that occurs mostly at low speeds like driving in parking lots or stop and go traffic as defined in 19V-645 and N192268490. Driving at these speeds and braking feels like the brakes are completely failing and require excessive force on the brake pedal to stop. What do I do?
A D V E R T I S E M E N T S
- Beverly Hills , FL, USA