This data is from the NHTSA — the US gov't agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.
So how do you find out what problems are occurring? For this NHTSA complaint data, the only way is to read through the comments below. Any duplicates or errors? It's not us.
About 165,000 miles brake pedal started to pulsate at low speed when stopping.started out only when I would be turning left, now does it going staight, about 170,000 miles now.had new caliper on driver side, new hub assemblie and sensor on passenger side, brake system flushed, still have problems with brake pedal pulsating, does not matter what kind of road I'm on.
The contact owns a 2002 Chevrolet Silverado. While driving at a low speed, the contact applied the brake pedal and the ABS kicked in; however, there was a loss of brake function. The stopping distance of the vehicle was dramatically reduced. The vehicle was taken to a mechanic who stated that there was a wheel bearing sensor failure. The entire wheel bearing with the sensor was replaced, but the failure recurred multiple times. The contact researched and found NHTSA campaign number: 05V379000. The manufacturer was notified of the issue. The approximate failure mileage was 90,000.
ABS stopped brake pedal from going down. By the time I lifted and pumped again vehicle struck young girl. Travel was about six feet. There is a recall in other states but not ky.
Was starting out of driveway on slight slope. Applied brakes and antilock system kicked in. Under 5mph. Rolled in front of oncoming traffic. A truck had to veer to avoid collision with us. Became aware there is a known problem but vehicle hadn't been recalled because it is in Kentucky. #05V379000 recall should be extended to ky because of salt for snow and gravel roads.
- Livingston, KY, USA
Search CarComplaints.com for these popular complaint phrases...
The contact owns a 2002 Chevrolet Silverado. While driving 35 mph, the vehicle would not stop when the brake pedal was depressed. The contact had to use the emergency brake to force the vehicle to stop. The dealer diagnosed that the brake lines were leaking. The vehicle was not repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 99,610.
When you are traveling real slow or parking the antilock brakes kick in making I difficult to stop. I talked to Chevrolet customer service and they will do nothing for me. Although it is the same design issue that they have recalled on recall #05V37900, the say my truck is not covered.
I own a 2002 Chevy Silverado, and I have had the brakes fail on me multiple times the first time I encountered this issue was in early January when I was driving to school and I approached a stop sign and when I went to slow down I had no brakes and my vehicle rolled into the street luckily I wasn't go very fast and there were no cars coming so I didn't get hit. The repairs cost me 175$, that was repairing the problem to bare minimum (single brake line replacement). After I fixed that issue I ran into another problem, the ABS brake system will now spontaneously turn on when I come to a stop, it resulted in a three car crash, I was going to back into a parking spot and when I pulled my truck forward I tried to stop and the ABS locked up my trucks brakes (not slippery out) and forced me to hit two other vehicles, one was majorly damaged and another with minor yet still severe damage, this accident ended with me paying more in insurance and having to fix the damages on my own vehicle out of pocket. I will also in the very near future need to replace all my brake lines because they are on the verge of failing and I am being priced near 900$ for the repairs, I am not sure how much the ABS problem is going to be because the truck has been parked ever since the incident, the brakes are costing me a lot of money and hardship.
The contact owns a 2002 Chevrolet Silverado. While slowing down at a stop light at approximately 5 mph, the brake pedal failed to respond and the contact had to depress the brake pedal several times to stop the vehicle. Once the vehicle stopped, the ABS and brake warning indicators illuminated. The contact mentioned that the vehicle was recently repaired under NHTSA campaign number: 05V379000 (service brakes, hydraulic). The vehicle was taken to the dealer. The technician was unable to diagnose the failure. However, the brakes were replaced and the failure persisted. The failure recurred on several occasions. The manufacturer was made aware of the failure. The approximate failure mileage was 103,000. Updated 04/06/15 updated 9/27/2017
The contact owns a 2002 Chevrolet Silverado. The contact stated that while driving at approximately 10 mph, the brakes failed. The vehicle was taken to an independent mechanic, who diagnosed that the brake line was rusted and the ABS module needed to be replaced. The vehicle was repaired. The manufacturer was notified of the failure. The approximate failure mileage was 63,000....updated 03/31/15 updated 6/22/2015
As I was driving I approached a traffic light and applied the brakes. As I applied them, the pedal never offered much resistance and eventually went to the floor. I suspected that a flexible brake line had ruptured so I got off the street as quickly as I could. I examined the inside of all of the wheels where I thought that brake fluid might be evident. There was none to be seen. I limped home with the vehicle and examined it more closely. There was a major leak under the floor of the vehicle in a rigid brake line leading to the anti-lock brake controller. I researched the issue on the internet and found that GM has refused to issue a recall for rusted brake lines. In my opinion these lines should be of the highest quality material to be found. GM, however, must not think that the safety of their customers warrants any better materials than the rust prone metal that the brake lines are manufactured from.
On 26 September 2011 said vehicle had to have all brake lines and other brake parts replaced due to excessive rust/rusting out at 71,012 well maintained miles at a cost of $1300 plus. On 30 December 2014 said vehicle had to have all fuel lines and fuel filler tube replaced due to excessive rust/rusting out at 90,790 well maintained miles at a cost of $1800.oo plus.
The contact owns a 2002 Chevrolet Silverado. While driving approximately 45 mph, the brakes failed to stop the vehicle and the ABS warning light illuminated. The vehicle was taken to an independent mechanic for diagnostic testing and the mechanic informed the contact that there was brake line failure. The brake lines were replaced. The manufacturer was not notified of the failure. The approximate failure mileage was 144,000.
The contact owns a 2002 Chevrolet Silverado. The contact stated that while driving 45 mph engaging the brakes, the brake pedal sank to the floor and the vehicle failed to stop. The vehicle was taken to an independent mechanic where the technician diagnosed that the brake line had rusted and needed to be replaced. The brake line was replaced. The manufacturer was not made aware of the failure. The failure mileage was 115,000. The VIN was unavailable.
The contact owns a 2002 Chevrolet Silverado. When the brake pedal was depressed, the vehicle failed to respond. The contact had to use extreme force in order to stop the vehicle. In addition, the brake warning indicator illuminated. The vehicle was taken to an independent mechanic who repaired the brake lines, but the failure persisted on numerous occasions. The manufacturer was not notified. The VIN was unavailable. The approximate failure mileage was 100,000.
I own a 2002 Chevy Silverado 2500 4X4 pickup. My brake lines failed today and caused me to run into a parked car at work. My father has a 1999 Chevy Silverado 1500 4X4 that he bought brand new and garage kept and still almost had a bad accident due to his brake lines failing 3 years ago. When I GM going to realize that brake lines are not normal wear and tear. I own multiple vintage Chevy cars that are between 25 and 37 years old with the original brake lines. Why is it GM is waiting for people to be killed due to these problems. I chassis wash my truck as much as possible and also have friends and family with Silverado is year close to mine. All have same issues. Its sad that older GM cars have survived better than these newer built models. Now tomorrow I am going to have to spend alot of money on a part that should not fail. Why is it that my exhaust system on my car has stainless steel parts but yet the one part that should be absolutely made from stainless steel is not! sad that my exhaust will be in great shape as my brake lines fail! I have owned GM cars and truck my whole life and will no longer buy GM products. I have multiple other issues that many, many other Silverado owners have. How can thousands of Silverado and other make of GM cars and truck have so many of the same problems and GM not recall them. My exhaust manifolds have 2 broken bolts causing an exhaust leak due to broken bolts! I have engines from the 1960's with factory manifolds still installed and no broken bolts. Put the [xxx] american made steel mills back up and stop buying this cheap metal because for what most of us pay for our cars and truck the least GM can do is put quality parts in them. Offering a brake line kit to have installed in GM dealerships is not helping people that need there truck like I do daily. Recall the [xxx] brake line problem models and fix them right! information redacted pursuant to the Freedom Of Information Act (FOIA), 5 U.S.C. 552(B)(6).
The contact owns a 2002 Chevrolet Silverado. The contact stated that the brakes failed and the brake pedal traveled to the floorboard. The contact inspected the vehicle and discovered a brake fluid leak and that the brake lines were corroded. The manufacturer was made aware of the failure. The vehicle was not repaired. The failure mileage was 138,000.
Was trying to slow down while coming over a hill to a known stop light. Applied brakes and brake pedal went to the floor. No brakes. No warning light, no other indicator. Was able to come to a stop on the side of the road without hitting anyone. Puddle of brake fluid could be found under the truck. Had to replace all the brake lines as they had rusted out totally. Lucky no one was hurt, but if I had been closer into the city it wouldn't have been pretty.
The contact owns a 2002 Chevrolet Silverado. The contact stated that the brakes failed after recently being replaced. The vehicle was not diagnosed or repaired. The contact also stated that the same issue happened previously and the brake lines were replaced. The manufacturer was made aware of the failure. The failure and current mileage was 50,000.
We have replaced the driver side brake lines on my truck at least 3 times already in the last in the last year and a half. Luckily every time but one it was discovered before I pulled out of the driveway.
A D V E R T I S E M E N T S
- Pahoa, HI, USA