ABS Problem- No Awd

7.0

pretty bad
Typical Repair Cost:
No data
Average Mileage:
112,500 miles
Total Complaints:
2 complaints

Most Common Solutions:

  1. not sure (2 reports)
2003 Buick Rendezvous brakes problems

brakes problem

Find something helpful? Spread the word.
Get notified about new defects, investigations, recalls & lawsuits for the 2003 Buick Rendezvous:

Unsubscribe any time. We don't sell/share your email.

2003 Buick Rendezvous Owner Comments

problem #2

Dec 152012

Rendezvous CLX 3.4L V6

  • Automatic transmission
  • 120,000 miles

A D V E R T I S E M E N T S

Over all have been very happy with this car. bought used in 2005 with 21,000 miles on it. now have 162,000. wife loves it. car is a loaded cream puff with everything on it. has always driven and handled well, very nice ride. I am ,however, the fixer in the family and have been though most of the run of problems with the car. I have abs brake/ no awd problem at the moment with no joy. Replaced the left front hub/ sensor, full brake job on all wheels 2 times now. get brake chatter on left front wheel when slowing to turn left. car wares out rear brake pads fast, 3 sets so far. Window regulator clips are plastic junk, should have been metal from the start. Repaired 3 windows with liquid steel on the clips. Dealer would not tell me replacement clip could be found. wanted $150.00 each for new regulators. Had a valve job done at 140,000 miles to fix head problem/anti-freeze use. 3 batterys now. New one today with alternator change out. Changed out 2 water pumps & 1 starter. I would really like to fix the brake problem, with bad weather, no abs and all wheel drive is dangerous.

- Bob R., Leland, NC, US

problem #1

Nov 222014

Rendezvous CLX 3400

  • Automatic transmission
  • 105,000 miles

Nice vehicle, BUT I bought it for the all wheel drive. ABS wheel bearings have been replaced. Still the "code" tells the technician that the sensor is bad, this is the 3rd wheel bearing/ABS sensor. If the ABS doesn't work, than the all wheel system doesn't work. The fuel gauge doesn't work either. I'm wondering if the main "body computer" ECM is defective? OR, as many people have written about, that I have a wire chaffing problem. The search for the fix continues.

- David M., Laurium, MI, US

Not what you are looking for?