- September 9: BMW X1 Acceleration Lag Lawsuit Filed in Virginia news | 23 days ago
- August 21: BMW Water Pump Recall Issued After 'Thermal Events' recalls | 42 days ago
- August 8: BMW Overheated Starter Motors Cause Recall recalls | 55 days ago
- July 24: BMW Recalls 291,000 X3 SUVs Due to Cargo Rail Problems recalls | 70 days ago
- July 10: BMW Recalls 395,000 3 Series Vehicles Due to Takata Airbags recalls | 84 days ago
BMW TSB #123414
2011 BMW 528
TSB Document:
Affected Component: ELECTRICAL SYSTEM
- Summary
- N52T DME Fault CD9304: Diagnostic Hints for Bit-Serial Data Interface Communication. If there is a problem with communication on the Bit-serial data interface bus (BSD), the obvious symptoms are related to the oil service CBS functions. The DME must receive constant communication from the oil level sensor. Whenever this communication is disturbed, a fault is set and the following symptoms can be present: ? The remaining distance forecast to the next oil service is too short and not plausible in conjunction with the service history. ? The CBS engine oil service cannot be reset either in the Kombi or with the ISTA test plan. ? The engine oil level measurement is inactive and will not complete. The fault CD9304: Bit-serial data interface, signal: communication is stored in the DME. In addition, power management faults for undervoltage or overvoltage, as described in SI B12 12 13, could be stored as well. A faulty ignition coil may have damaged the DME; however, there is no DME fault code stored for te defective ignition coil.
Click a tab for more information.